LPWSPLISTEN callback function (ws2spi.h)
The LPWSPListen function establishes a socket to listen for incoming connections.
Syntax
LPWSPLISTEN Lpwsplisten;
int Lpwsplisten(
[in] SOCKET s,
[in] int backlog,
[out] LPINT lpErrno
)
{...}
Parameters
[in] s
Descriptor identifying a bound, unconnected socket.
[in] backlog
Maximum length to which the queue of pending connections can grow. If this value is SOMAXCONN, then the service provider should set the backlog to a maximum "reasonable" value. There is no standard provision to find out the actual backlog value.
[out] lpErrno
Pointer to the error code.
Return value
If no error occurs, LPWSPListen returns zero. Otherwise, a value of SOCKET_ERROR is returned, and a specific error code is available in lpErrno.
| Error Code | Meaning |
|---|---|
| The network subsystem has failed. | |
| Socket's local address is already in use and the socket was not marked to allow address reuse with SO_REUSEADDR. This error usually occurs at the time of Bind, but could be delayed until this function if the **bind** was to a partially wildcard address (involving ADDR_ANY) and if a specific address needs to be committed at the time of this function. | |
| Function is invoked when a callback is in progress. | |
| Socket has not been bound with LPWSPBind. | |
| Socket is already connected. | |
| No more socket descriptors are available. | |
| No buffer space is available. | |
| The descriptor is not a socket. | |
| Referenced socket is not of a type that supports the LPWSPListen operation. |
Remarks
To accept connections, a socket is first created with LPWSPSocket bound to a local address with LPWSPBind, a backlog for incoming connections is specified with LPWSPListen, and then the connections are accepted with LPWSPAccept. LPWSPListen applies only to sockets that are connection oriented (for example, SOCK_STREAM). The socket s is put into passive mode where incoming connection requests are acknowledged and queued pending acceptance by the Windows Sockets SPI client.
This function is typically used by servers that could have more than one connection request at a time: if a connection request arrives with the queue full, the client will receive an error with an indication of WSAECONNREFUSED.
LPWSPListen should continue to function rationally when there are no available descriptors. It should accept connections until the queue is emptied. If descriptors become available, a later call to LPWSPListen or LPWSPAccept will refill the queue to the current or most recent backlog, if possible, and resume listening for incoming connections.
A Windows Sockets SPI client can call LPWSPListen more than once on the same socket. This has the effect of updating the current backlog for the listening socket. Should there be more pending connections than the new backlog value, the excess pending connections will be reset and dropped.
The backlog parameter is limited (silently) to a reasonable value as determined by the service provider. Illegal values are replaced by the nearest legal value. There is no standard provision to find out the actual backlog value.
Requirements
| Requirement | Value |
|---|---|
| Minimum supported client | Windows 2000 Professional [desktop apps only] |
| Minimum supported server | Windows 2000 Server [desktop apps only] |
| Header | ws2spi.h |