Share via

Test.ZHeight (7d7f9f78-8066-4086-ab74-7270e0e0647a)

  • Article

This test verifies that device does not detect contacts that are not directly on the surface of the touchpad.

Test details

   
Specifications
  • Device.Input.Digitizer.PrecisionTouchpad.ContactTipSwitchHeight
Platforms
  • Windows 10, client editions (x86)
  • Windows 10, client editions (x64)
  • Windows 10, client editions (Arm64)
Supported Releases
  • Windows 10
  • Windows 10, version 1511
  • Windows 10, version 1607
  • Windows 10, version 1703
  • Windows 10, version 1709
  • Windows 10, version 1803
  • Windows 10, version 1809
  • Windows 10, version 1903
  • Next update to Windows 10
Expected run time (in minutes) 2
Category Compatibility
Timeout (in minutes) 120
Requires reboot false
Requires special configuration false
Type automatic

 

Additional documentation

Tests in this feature area might have additional documentation, including prerequisites, setup, and troubleshooting information, that can be found in the following topic(s):

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

To run this test, you will need precision capacitive contacts that can be placed 1mm above the surface of the touchpad and remain steady for a period of time. It is recommended that this test be performed by a robot or other precision mechanism.

  1. Place 1mm thick material on top of touchpad.

  2. Lower a precision contact until it just touches the non-conductive material.

  3. Remove the material.

  4. Leave contact in place above touchpad for 1 minute.

  5. Verify that no contact is reported and press P to manually pass the test. If contact is reported, press F to fail the test.

Troubleshooting

For generic troubleshooting of HLK test failures, see Troubleshooting Windows HLK Test Failures.

For troubleshooting information, see Troubleshooting Device.Input Testing.

More information

Command syntax

Command Description

ptlogo.exe Test.ZHeight.json

Runs the test.

 

File list

File Location

ptlogo.exe

<testbinroot>\input\PrecisionTouchpad\

config.json

<testbinroot>\input\PrecisionTouchpad\

Test.ZHeight.json

<testbinroot>\input\PrecisionTouchpad\