Test.LinearityDiagonal (5eba881d-82b3-40ec-8a75-ad1a320fcb56)

This test verifies that the touchpad reports a straight line (that corresponds to contact movement) when a single contact is moved diagonally across the surface of a touchpad (within a tolerance of .5mm).

Test details

   
Specifications
  • Device.Input.Digitizer.PrecisionTouchpad.Jitter
Platforms
  • Windows 10, client editions (x86)
  • Windows 10, client editions (x64)
  • Windows 10, client editions (Arm64)
Supported Releases
  • Windows 10
  • Windows 10, version 1511
  • Windows 10, version 1607
  • Windows 10, version 1703
  • Windows 10, version 1709
  • Windows 10, version 1803
  • Windows 10, version 1809
  • Windows 10, version 1903
  • Next update to Windows 10
Expected run time (in minutes) 2
Category Compatibility
Timeout (in minutes) 120
Requires reboot false
Requires special configuration false
Type automatic

 

Additional documentation

Tests in this feature area might have additional documentation, including prerequisites, setup, and troubleshooting information, that can be found in the following topic(s):

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

This test requires very precise movement in a straight line. We recommend that you perform this test by using a precision rig or other precision device that is capable of straight line movement without any jitter.

  1. Place two precision contacts slightly outside the top left corner of the touchpad.

  2. Drag that contact in a straight line from the top left to the bottom right corner of the touchpad.

  3. Drag the contact from the bottom right up to the top left.

  4. Repeat this pattern for a total of five iterations.

Troubleshooting

For generic troubleshooting of HLK test failures, see Troubleshooting Windows HLK Test Failures.

For troubleshooting information, see Troubleshooting Device.Input Testing.

Error Description/Workaround

[15] contact didn't move in straight line

Reported path strayed varied from a straight line by more than the allowed tolerance.

[14] packet too far from edge: ###

  • Swipe must start at or before the edge.

  • Swipe must go all the way to the opposite edge. Performing swipe too quickly might not allow the device to fully report.

 

More information

Command syntax

Command Description

ptlogo.exe Test.LinearityDiagonal.json

Runs the test.

 

File list

File Location

ptlogo.exe

<testbinroot>\input\PrecisionTouchpad\

config.json

<testbinroot>\input\PrecisionTouchpad\

Test.LinearityDiagonal.json

<testbinroot>\input\PrecisionTouchpad\