Share via

Test.PositionalAccuracy (352586f7-adf8-439e-8b34-d5bdca83a86e)

  • Article

This test verifies that the position reported from the device accurately represents the position a contact was placed on the touchpad.

Test details

   
Specifications
  • Device.Input.Digitizer.PrecisionTouchpad.Accuracy
Platforms
  • Windows 10, client editions (x86)
  • Windows 10, client editions (x64)
  • Windows 10, client editions (Arm64)
Supported Releases
  • Windows 10
  • Windows 10, version 1511
  • Windows 10, version 1607
  • Windows 10, version 1703
  • Windows 10, version 1709
  • Windows 10, version 1803
  • Windows 10, version 1809
  • Windows 10, version 1903
  • Next update to Windows 10
Expected run time (in minutes) 2
Category Compatibility
Timeout (in minutes) 120
Requires reboot false
Requires special configuration false
Type automatic

 

Additional documentation

Tests in this feature area might have additional documentation, including prerequisites, setup, and troubleshooting information, that can be found in the following topic(s):

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

By following the directions on the screen, you will perform three taps in an indicated area on the touchpad. After each set of three taps, the instructions will tell you move to a different area, for a total of 15 taps. If the instructions say to tap in a corner, tap as close to that corner as possible. For each iteration, do the following:

  1. Tap the location that is specified on the screen.

    Note

       The location is calculated as a 13mm square area. For example, if the instructions say Top Left Corner, you should tap somewhere in the top-left most 13mm of the touchpad.

     

  2. If a tap is registered by the device, the iteration will automatically pass and move on to the next iteration.

  3. If no tap is registered by the device, you must manually fail the iteration.

Troubleshooting

For generic troubleshooting of HLK test failures, see Troubleshooting Windows HLK Test Failures.

For troubleshooting information, see Troubleshooting Device.Input Testing.

More information

Command syntax

Command Description

ptlogo.exe Test.PositionalAccuracy.json

Runs the test.

 

File list

File Location

ptlogo.exe

<testbinroot>\input\PrecisionTouchpad\

config.json

<testbinroot>\input\PrecisionTouchpad\

Test.PositionalAccuracy.json

<testbinroot>\input\PrecisionTouchpad\