Test.DefaultMode
This test verifies that device reports properly when put into default mode.
Test details
Associated requirements |
Device.Input.PrecisionTouchpad.HIDCompliance.DefaultMode |
Platforms |
Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86 |
Expected run time |
~2 minutes |
Categories |
Certification |
Type |
Manual |
Running the test
Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.
Turn off test signing by running bcdedit /set testsigning off from an elevated command prompt and then restarting the computer.
Start the test.
Move your finger on touchpad and verify the following:
The mouse cursor moves as expected.
No PTP is reported. The test should show no contact visualization on the screen, and clicking the pad should not turn the bar green at the bottom of the screen.
If the above conditions are met, press P to manually pass the test. Otherwise, press F to fail the test.
Turn on test signing by running bcdedit /set testsigning on from an elevated command prompt and then restarting the computer.
Troubleshooting
For troubleshooting information, see Troubleshooting Device.Input Testing.
More information
Command syntax
| Command | Description |
|---|---|
ptlogo.exe Test.DefaultMode.json |
Runs the test. |
File list
| File | Location |
|---|---|
ptlogo.exe |
<testbinroot>\input\PrecisionTouchpad\ |
config.json |
<testbinroot>\input\PrecisionTouchpad\ |
Test.DefaultMode.json |
<testbinroot>\input\PrecisionTouchpad\ |