Intel 815-based SDB (Windows CE 5.0)
In general, the only changes you need to make in the BIOS are in the PnP and PCI Settings menu. You can choose the defaults for all other settings.
Asus TUSL2-C Intel 815EP SDB CMOS Setup
The following table shows the standard CMOS setup for the Asus TUSL2-C Intel 815EP SDB.
| Setting | Description |
|---|---|
| Date | Your local date |
| Time | Your local time |
| Primary Master | Auto
Supports the ATAPI CD-ROM drive that must be the primary master. |
| Primary Slave | None
A hard drive can be installed on a CEPC and boot to other operating systems, or it can be used to load images. |
| Secondary Master | None |
| Secondary Slave | None |
| Drive A | 1.44 and 3.5 inch |
| Drive B | None |
| Floppy 3 Mode Support | Disabled |
| Video | EGA/VGA |
| Halt On | No errors |
Asus TUSL2-C Intel 815EP SDB BIOS Setup
The following table shows the BIOS setup.
| Setting | Description |
|---|---|
| Boot Virus Detection | Disabled |
| Processor Serial Number | Not applicable |
| CPU Level 1 Cache | Enabled |
| CPU Level 2 Cache | Enabled |
| CPU Level 2 Cache ECC Check | Disabled |
| BIOS Update | Enabled |
| Quick Power On Self Test | Enabled |
| HDD Sequence SCSI/IDE First | IDE |
| Boot Sequence | A, CDROM, C
It is possible to create bootable CD-ROMs and load Nk.bin from the CD-ROM |
| Boot Up Floppy Seek | Disabled |
| Floppy Disk Access Control | R/W |
| IDE HDD Block Mode Sectors | HDD MAX |
| HDD S.M.A.R.T. Capability | Disabled |
| PS/2 Mouse Function Control | Auto |
| OS/2 Onboard Memory > 64M | Disabled |
| PCI/VGA Palette Snoop | Disabled |
| Video ROM BIOS Shadow | Enabled |
| C8000-CBFFF | Disabled |
| CC000-CFFFF | Disabled |
| D0000-D3FFF | Disabled |
| D4000-D7FFF | Disabled |
| D8000-DBFFF | Disabled |
| DC000-DFFFF | Disabled |
| Boot Up NumLock Status | On |
| Typematic Rate Setting | Disabled |
| Typematic Rate (Chars/Sec) | 6 |
| Typematic Delay (Msec) | 250 |
| Security Option | System |
Asus TUSL2-C Intel 815EP SDB Chipset Setup
The following table shows the chipset setup for the Asus TUSL2-C Intel 815EP SDB.
| Setting | Description |
|---|---|
| SDRAM Configuration | By SPD |
| CDRAM CAS Latency | By SPD |
| SDRAM RAS to CAS Delay | By SPD |
| SDRAM RAS Prechard Time | By SPD |
| DRAM Idle Timer | 8T |
| DRAM MA Wait State | Normal |
| Snoop Ahead | Enabled |
| Host Bus Fast Data Ready | Disabled |
| 16-bit I/O Recovery Time | 1 BUSCLK |
| 8-bit I/O Recovery Time | 1 BUSCLK |
| Graphics Aperture Size | 64MB |
| Video Memory Cache Mode | UC |
| PCI 2.1 Support | Enabled |
| Memory Hole at 15M-16M | Disabled |
| Onboard FDC Controller | Enabled |
| Onboard FDC Swap A&B | No Swap |
| Onboard Serial Port 1 | 3F8H/IRQ4 |
| Onboard Serial Port 2 | 2F8H/IRQ3 |
| Onboard Parallel Port | 378H/IRQ7 |
| Parallel Port Mode | ECP+EPP |
| ECP DMA Select | 3 |
| UART2 Use Infrared | Disabled |
| Onboard PCI IDE Enable | Primary. This disables the secondary IDE channel. |
| IDE Ultra DMA Mode | Auto |
| IDE0 Master PIO/DMA Mode | Auto |
| IDE0 Slave PIO/DMA Mode | Auto |
| IDE1 Master PIO/DMA Mode | Auto |
| IDE1 Slate PIO/DMA Mode | Auto |
Asus TUSL2-C Intel 815EP SDB Power Management Setup
The following table shows the power management setup for the Asus TUSL2-C Intel 815EP SDB.
| Setting | Description |
|---|---|
| Power Management | User Defined |
| Video Off Option | Suspend->Off |
| Video Off Method | DPMS Off |
| HDD Power Down | Disabled |
| Suspend Mode | Disabled |
| PWR Button < 4 seconds | Soft Off |
| PNP OS Installed | No. This is required. |
| Slot 1 IRQ | If IRQ = 0 and IoBase = 0 in AutoExec.bat on the boot disk, the boot loader searches for the Ethernet Debug Card. |
| Slot 2 IRQ | Auto |
| Slot 3 IRQ | Auto |
| Slot 4 IRQ | Auto |
| PCI Latency Timer | 0 PCI Clock |
| IRQ 3 Used by ISA | No/ICU |
| IRQ 4 Used by ISA | No/ICU |
| IRQ 5 Used by ISA | Yes. This is for the ISA NE2000 NIC. IRQ 5 and base address 340h are used; however, you can use a different IRQ and base address if you modify the call to LoadCEPC.exe on your boot disk. |
| IRQ 7 Used by ISA | No/ICU |
| IRQ 9 Used by ISA | No/ICU |
| IRQ 10 Used by ISA | No/ICU |
| IRQ 11 Used by ISA | Yes, this IRQ is used by the ISA-based PCMCIA reader. |
| IRQ 12 Used by ISA | No/ICU |
| IRQ 14 Used by ISA | No/ICU |
| IRQ 15 Used by ISA | No/ICU |
| DMA 1 Used by ISA | No/ICU |
| DMA 3 Used by ISA | No/ICU |
| DMA 5 Used by ISA | No/ICU |
| ISA MEM Block BASE | No/ICU |
| SYMBIOS SCSI BIOS | Auto |
| USB IRQ | Enabled |
| VGA BIOS | PCI/AGP |
| Sequence | Enabled |
| PWR Up On Modem Act | Disabled |
| AC PWR Loss Restart | Disabled |
| Power Up By Keyboard | Disabled |
| Wake On LAN | Disabled |
| Automatic Power Up | Disabled |
See Also
CEPC-based SDBs | How-to Topics
Send Feedback on this topic to the authors