Configure an X.25 smart card
Applies To: Windows Server 2003, Windows Server 2003 R2, Windows Server 2003 with SP1, Windows Server 2003 with SP2
To configure an X.25 smart card
Install the X.25 smart card (according to the manufacturer's instructions).
Make sure your X.25 smart card is configured with the X.3-parameter values as shown in the following table.
Configure the X.25 ports for remote access in Routing and Remote Access.
| Parameter number | X.3 parameter | Value |
|---|---|---|
1 |
PAD Recall |
0 |
2 |
Echo |
0 |
3 |
Data Fwd Char |
0 |
4 |
Idle Timer |
1 |
5 |
Device Control |
0 |
6 |
PAD Service Signals |
1 |
7 |
Break Signal |
0 |
8 |
Discard Output |
0 |
9 |
Padding after CR |
0 |
10 |
Line Folding |
0 |
11 |
Not Set |
|
12 |
Flow Control |
0 |
13 |
Linefeed Insertion |
0 |
14 |
Padding after LF |
0 |
15 |
Editing |
0 |
16 |
Character Delete |
0 |
17 |
Line Delete |
0 |
18 |
Line Display |
0 |
19 |
Editing PAD Srv Signals |
0 |
20 |
Echo Mask |
0 |
21 |
Parity Treatment |
0 |
22 |
Page Wait |
0 |
Important
- Failure to set these values as shown prevents remote access that uses an X.25 smart card from functioning properly. For more information on setting these values, see the instructions provided with your X.25 smart card.
Notes
A communication driver for the X.25 smart card that emulates communication ports is supplied by the hardware manufacturer or by another company.
Make sure that the speed of the leased line can support all the serial communication (COM) ports at all speeds at which clients will dial in. For example, four clients connecting at 9,600 bps (through dial-up PADs) will require a 38,400-bps (4 times 9,600) leased line on the server end. If the leased line does not have adequate bandwidth, it can cause time-outs and can cause the performance for connected clients to degrade.
Information about functional differences
- Your server might function differently based on the version and edition of the operating system that is installed, your account permissions, and your menu settings. For more information, see Viewing Help on the Web.
See Also
Concepts
Working with MMC console files
X.25
Configure ports for remote access