Snacfg Diagnostic
Purpose
Allows you to view and configure settings for event logging (auditing), and view or change the connection designated to receive NetView alerts.
Note
Configuration settings specified with snacfg diagnostic correspond to diagnostic settings configured with the SNA Manager.
Syntax
snacfg [#configpath] diagnostic /list
snacfg [#configpath] diagnostic [options]
where
# configpath
Specifies the path of the configuration file to view or change. If the configuration path is omitted, Host Integration Server will attempt to access the configuration file on the local system, using the path \Program Files\Host Integration Server\SYSTEM\CONFIG\COM.CFG.
/list
Generates a list that tells the settings for event logs (auditing), the name of the NetView management connection (if one has been specified), and the default connection for the DISPLAY verb (if one has been specified).
/logserver: servername
Specifies a centralized server on which event logs for this Host Integration Server installation should be stored.
If /logserver: is typed without servername, the setting reverts to the default, which is to store event logs for the local server on the local server.
/auditlevel:{ 6| 8| 10| off}
Sets the level of Host Integration Server events to be recorded in the Windows Event Log. These events can be viewed with the Windows Event Viewer, which is described in the Windows documentation. The following table describes the available levels:
| Level | Description | Events to be recorded |
|---|---|---|
| 6 | Detailed problem analysis | All events that can be recorded |
| 8 | General information messages | General activity but not all events |
| 10 | Significant system events | Major events only |
| off | Auditing disabled | No events |
/popupserver: servername
Specifies the server to which pop-up error messages for this Host Integration Server installation should be routed.
Pop-up messages will always appear on the local server; routing them to a remote server means they will appear on both the remote and local server.
If /popupserver: is typed without servername, the setting reverts to the default, which is the local server.
/netviewconn: connectionname
Specifies the name of the connection through which NetView alerts are sent. The connection called connectionname must already exist.
If /netviewconn: is typed without connectionname, the setting is cleared so that the configuration contains no NetView connection name.
/cnosdisplayconn: connectionname
Specifies the default connection to be used for the DISPLAY verb when no connection is provided. The connection called connectionname must already exist.
If /cnosdisplayconn: is typed without connectionname, the setting is cleared so that the configuration contains no default connection for the DISPLAY verb.