Compartilhar via


Parallel Port Architecture (Windows CE 5.0)

Send Feedback

Five popular types of parallel ports exist. You can configure many ports to work in any of these modes. The following table shows the types of parallel ports.

Parallel port type Description
Standard parallel port (SPP or AT) Standard parallel ports send 8 bits of data in parallel mode, but receive data only 4 bits at a time.
Bi-directional (PS/2 or BPP) Bi-directional parallel ports send and receive data 8 bits at a time.
Enhanced parallel port (EPP) Many EPP ports can handle PS/2 bi-directional communications.
Extended capability port (ECP) ECP can handle PS/2 bi-directional communications, but must be put in this mode by software. Several BIOS setup programs offer the ability to perform this task. You can also run a software application to select the bi-directional mode of an ECP port by setting the most significant bits (bits 7, 6, and 5) of (LPT1 PORT ADDRESS + 0x402) to 001. Relying on a software solution could cause problems if you forget to run the application or if other software changes the port mode. Therefore, if your parallel port supports only ECP, you should install a separate parallel port ISA card.
ECP+EPP A standard ECP port can be put in a mode to emulate a bi-directional PS/2 port, but an EPP port cannot. An ECP+EPP port can be put into ad additional mode to emulate EPP. ECP+EPP ports have the same configuration challenge as described for ECP ports.

Parallel Cable Customization

You need a custom parallel cable to use Target Control to transfer an run-time image. This cable requires a DB-25 male connector at both ends. The following table shows how to map the pins.

Pin Mapped to
1 10
2 Same
3 Same
4 Same
5 Same
6 Same
7 Same
8 Same
9 Same
10 1
11 14
12 16
13 17
14 11
15 Not connected on either end
16 12
17 13
18 Same
19 Same
20 Same
21 Same
22 Same
23 Same
24 Same
25 Same

See Also

How-to Topics

Send Feedback on this topic to the authors

Feedback FAQs

© 2006 Microsoft Corporation. All rights reserved.