_mm256_nmsub_ps
[Note: This document describes a pre-release version of Visual Studio 2010 SP1 and may be revised in any later version.]
Visual Studio 2010 SP1 is required.
Microsoft Specific
Generates the FMA4 YMM instruction vfnmsubps to perform a single-round floating-point negative multiply-subtract of its sources.
__m256 _mm256_nmsub_ps (
__m256 src1,
__m256 src2,
__m256 src3
);
Parameters
[in] src1
A 256-bit parameter that contains eight 32-bit floating-point values.[in] src2
A 256-bit parameter that contains eight 32-bit floating-point values.[in] src3
A 256-bit parameter that contains eight 32-bit floating-point values.
Return value
A 256-bit result r that contains eight 32-bit floating-point values.
r[i] := -(src1[i] * src2[i]) - src3[i];
Requirements
Intrinsic |
Architecture |
---|---|
_mm256_nmsub_ps |
FMA4 |
Header file <intrin.h>
Remarks
Each of the eight single-precision floating-point values in src1 is multiplied by the corresponding value in src2. The result is negated, the corresponding value in src3 is subtracted from it, and the result is stored as the corresponding value in the destination. Each multiply-negate-subtract is performed with a single round at the end, as if intermediate results were computed to infinite precision.
The vfnmsubps instruction is part of the FMA4 family of instructions. Before you use this intrinsic, you must ensure that the processor supports this instruction. To determine hardware support for this instruction, call the __cpuid intrinsic with InfoType = 0x80000001 and check bit 16 of CPUInfo[2] (ECX). This bit is 1 when the instruction is supported, and 0 otherwise.
Example
#include <stdio.h>
#include <intrin.h>
int main()
{
__m256 a, b, c, d;
int i;
for (i = 0; i < 8; i++) {
a.m256_f32[i] = i;
b.m256_f32[i] = 2.;
c.m256_f32[i] = 3.;
}
d = _mm256_nmsub_ps(a, b, c);
for (i = 0; i < 8; i++) printf_s(" %.3f", d.m256_f32[i]);
printf_s("\n");
}
-3.000 -5.000 -7.000 -9.000 -11.000 -13.000 -15.000 -17.000
See Also
Reference
FMA4 Intrinsics Added for Visual Studio 2010 SP1
Change History
Date |
History |
Reason |
---|---|---|
March 2011 |
Added this content. |
SP1 feature change. |