Extended TAPI Functions

A version of this page is also available for

Windows Embedded CE 6.0 R3

4/8/2010

The following functions are used with Extended TAPI.

Function	Description
lineGetCallBarringCaps	Retrieves the barring modes supported by the radio hardware and network.
lineGetCallBarringState	Retrieves the current barring state for a given mode. Not implemented for Code-Division Multiple Access (CDMA).
lineGetCallWaitingCaps	Retrieves the set of media modes for which call waiting is supported by the radio hardware and network.
lineGetCallWaitingState	Retrieves the list of media modes for which call waiting is enabled. Not implemented for CDMA.
lineSetCurrentAddressID	Retrieves the current line address ID. Not implemented for CDMA.
lineGetCurrentHSCSDStatus	Retrieves the current non-transparent High Speed Circuit Switched Data (HSCSD) configuration. Not implemented for CDMA.
lineGetCurrentOperator	Retrieves the network operator on which the device is currently registered. Not implemented for CDMA.
lineGetCurrentSystemType	Retrieves the current line system type.
lineGetEquipmentState	Retrieves the state of the radio transmitter and receiver.
lineGetGeneralInfo	Retrieves general device information about the radio hardware, the radio software, the serial number, subscriber identity, and others.
lineGetGPRSClass	Retrieves the General Packet Radio Service (GPRS) class of the device and network. Not implemented for CDMA.
lineGetHSCSDCaps	Retrieves the HSCSD device capabilities. Not implemented for CDMA.
lineGetHSCSDState	Retrieves the non-transparent HSCSD configuration to be applied during the next data call. Not implemented for CDMA.
lineGetMuteState	Retrieves the mute state of the device.
lineGetNumberCalls	Retrieves all three call counts for the given line.
lineGetOperatorStatus	Retrieves the lists of preferred and available operators. Not implemented for CDMA.
lineGetRadioPresence	Determines whether a radio module is present or not.
lineGetRegisterStatus	Retrieves the network registration status of the device.
lineGetSendCallerIDState	Indicates if Caller ID info is sent on a mobile-device-originated call. Not implemented for CDMA.
lineGetUSSD	Reads an Unstructured Supplementary Service Data (USSD) message. Not implemented for CDMA.
lineRegister	Registers the device with a particular network operator. Not implemented for CDMA.
lineSendUSSD	Sends a USSD message. Not implemented for CDMA.
lineSetCallBarringPassword	Changes the call-barring password. Not implemented for CDMA.
lineSetCallBarringState	Sets call barring of media modes for a given call-barring mode. Not implemented for CDMA.
lineSetCallWaitingState	Sets call waiting for a given set of media modes. Not implemented for CDMA.
lineSetCurrentAddressID	Sets the current line address ID. Not implemented for CDMA.
lineSetEquipmentState	Sets the state of the radio transmitter and receiver.
lineSetGPRSClass	Sets the GPRS class of the device and the network. Not implemented for CDMA.
lineSetHSCSDState	Sets the non-transparent HSCSD configuration prior to a data call. Not implemented for CDMA.
lineSetMuteState	Sets the mute state.
lineSetPreferredOperator	Sets or deletes preferred operators. Not implemented for CDMA.
lineSetSendCallerIDState	Sets whether or not Caller ID is sent on a mobile-device-originated call. Not implemented for CDMA.
lineUnregister	Deregisters the device from the current network operator. > [!NOTE] > This function is not supported for CDMA.

See Also

Other Resources

Extended TAPI