Udostępnij za pośrednictwem

Test.ConvergeDivergeDiagonal (67e82275-e184-466c-8539-8cdf5103df2a)

  • Artykuł

This test verifies that two contacts are reported properly when converged and diverged within 14 millimeters of each other.

Test details

   
Specifications
  • Device.Input.Digitizer.PrecisionTouchpad.FingerSeparation
Platforms
  • Windows 10, client editions (x86)
  • Windows 10, client editions (x64)
  • Windows 10, client editions (Arm64)
Supported Releases
  • Windows 10
  • Windows 10, version 1511
  • Windows 10, version 1607
  • Windows 10, version 1703
  • Windows 10, version 1709
  • Windows 10, version 1803
  • Windows 10, version 1809
  • Windows 10, version 1903
  • Next update to Windows 10
Expected run time (in minutes) 2
Category Compatibility
Timeout (in minutes) 120
Requires reboot false
Requires special configuration false
Type automatic

 

Additional documentation

Tests in this feature area might have additional documentation, including prerequisites, setup, and troubleshooting information, that can be found in the following topic(s):

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

This test requires contacts that move very precisely in very specific distances. It is recommended that a precision rig or robotic solution is used to perform these tests.

  1. Place two 7 millimeter precision contacts on touchpad device next to each other vertically separated by distance as instructed on the screen.

  2. As instructed, move contacts diagonally (at a 45 degree angle) either towards each other or apart. Five iterations per direction for both converge and diverge. If the two contacts remain distinct and no errors are detected, the test will automatically pass each iteration and advance to the next.

Troubleshooting

For generic troubleshooting of HLK test failures, see Troubleshooting Windows HLK Test Failures.

For troubleshooting information, see Troubleshooting Device.Input Testing.

If you get an error of "[17] not enough separate of points" or "[18] too much separation of points: ####", ensure that the widest distance between two contacts is always > 30mm and the smallest distance is always < 11mm.

More information

Command syntax

Command Description

ptlogo.exe Test.ConvergeDivergeDiagonal.json

Runs the test.

 

File list

File Location

ptlogo.exe

<testbinroot>\input\PrecisionTouchpad\

config.json

<testbinroot>\input\PrecisionTouchpad\

Test.ConvergeDivergeDiagonal.json

<testbinroot>\input\PrecisionTouchpad\