Deploy IP address types on a Mediation Server for Lync Server 2013

 

Topic Last Modified: 2016-07-28

Using Topology Builder, perform the steps in the following procedure to deploy IP address types on a Mediation Server.

To deploy IP address types on a Mediation Server

• In Topology Builder, under Mediation pools, right-click the server within a pool, and then select Edit Properties. (Alternatively, select the server, and then click Edit Properties from the Action menu.)

• In the Edit Properties dialog box, select the IP address type that you want to configure. For a dual-stack configuration, select Enable IPv4 and Enable IPv6, as shown in the following figure.

  Edit Properties dialog box for the Mediation Server pool

  

  • Use all configured IP addresses. Select this option if you want to allow any IP address defined on the computer to be used.

    Note

    This is the recommended option for IP version 6 (IPv6) configurations.

  • Limit service usage to selected IP addresses. Select this option to specify a specific address to use on the new server. If you select this option, you must enter a value for Primary IP address.

  • Primary IP address. Enter an IP address that the server will use for all communications except public switched telephone network (PSTN). The IP address entered must match the format of the select address type.

  • PSTN IP address. Define a PSTN IP address when a Mediation Server is standalone. This address must match the format of the selected address type.

    Note

    The installation of additional network interface cards (NIC)s to support the PSTN IP address configuration for Lync Server 2013 is not supported on collocated Mediation Server roles. For more information about supported NIC configurations for Lync Server 2013, see Server hardware platforms for Lync Server 2013.