Udostępnij za pośrednictwem

Hyper-V : Parent Partition Network Card Configuration

  • Artykuł

It is important to get the network card configuration right in the parent partition for Hyper-V in Windows Server 2008/R2. 

Common problems include:

  • A-Records and PTR’s registered for the Parent Partition under multiple IP addresses
  • NetBIOS conflicts
  • Unwanted traffic going through network cards that you want to dedicate to, for example, VM’s or iSCSI.

These problems have nothing to do with Hyper-V actually.  They’re just issues you can face with any server containing more than one network card.

Step #1: Ensure that you have a good naming convention for you network cards

As you can see I have explicitly named by network cards.  One for the parent partition, one for the VM’s.  If you have one or more network cards for VM’s or iSSCI, name them accordingly.

NIC List

 

Step #2 : Ensure that the parent partition uses the right network card

In the image below you can see that the Parent Partition network card is first in the order.  This means that network services will attempt to use this interface before the VM NIC #1.

connection order

Step #3 : Ensure that the VM or iSCSI NIC does not register itself in DNS

Make sure that the network cards you dedicate for VM external networks do not register themselves in DNS.  Just configure the basic IP address and mask.  You do not need to include DNS servers etc.  Remember, you are more or less turning this network card into a virtual switch.

VM NIC1 - IP Addr VM NIC1 - DNS

Note that the “Register this connections addresses in DNS” is left un-ticked.  If you built you base OS for the parent partition with all the network cards patched, chances are that you will find more than one address registered for the server in DNS.  Ensure that you remove unwanted A-records and PTRs.

Step #4: Ensure that you disable NetBIOS over TCP/IP on the VM network cards

VM NIC1 - WINS