IOCTL_INTERNAL_USB_RESET_PORT IOCTL (usbioctl.h)
The IOCTL_INTERNAL_USB_RESET_PORT I/O control request is used by a driver to reset the upstream port of the device it manages. After a successful reset, the bus driver reselects the configuration and any alternative interface settings that the device had before the reset occurred. All pipe handles, configuration handles and interface handles remain valid.
Drivers should cancel all I/O requests and wait for them to complete before initiating this operation.
A driver that manages an individual interface on a composite device cannot reset the interface without resetting the entire composite device and all of its interfaces. For this reason, drivers that manage interfaces should attempt other types of error recovery, such as resetting pipes (_URB_PIPE_REQUEST), before resetting the interface.
This IOCTL must be sent at an IRQL of PASSIVE_LEVEL.
IOCTL_INTERNAL_USB_RESET_PORT is a kernel-mode I/O control request. This request targets the USB hub PDO.
Major code
IRP_MJ_INTERNAL_DEVICE_CONTROL
Input buffer
None.
Input buffer length
None.
Output buffer
None.
Output buffer length
None.
Status block
The bus or port driver sets Irp->IoStatus.Status to STATUS_SUCCESS or the appropriate error status.
Requirements
| Requirement | Value |
|---|---|
| Header | usbioctl.h (include Usbioctl.h) |