IOCTL_KS_RESET_STATE IOCTL (ks.h)
An application can use IOCTL_KS_RESET_STATE to return a pin to the state it was in at Acquire-time. The application passes IOCTL_KS_RESET_STATE with the parameters described below to the KsSynchronousDeviceControl function.
Major code
Input buffer
A client provides a buffer that contains the reset value (KSRESET_BEGIN, KSRESET_END) in the InBuffer parameter.
Input buffer length
InLength specifies size, in bytes, of the input buffer contents.
Output buffer
None.
Output buffer length
None.
Status block
If the request is successful, the Status member is set to STATUS_SUCCESS.
Remarks
Initiate a reset on a pin by sending IOCTL_KS_RESET_STATE with a value of KSRESET_BEGIN in the InBuffer parameter of KsSynchronousDeviceControl.
When the reset state is initiated, existing read and write requests are canceled. While in the reset state, any new read or write requests are rejected with STATUS_DEVICE_NOT_READY.
To terminate the reset state, send IOCTL_KS_RESET_STATE with a value of KSRESET_END.
Note that the reset state is not canceled by changing the pin state.
When the reset state is terminated, the pin can again accept new data and pass data to other connections.
Requirements
| Requirement | Value |
|---|---|
| Header | ks.h (include Ks.h) |