Translating Speaker-Configuration Requests
Note This information applies to Windows XP and earlier operating systems. Starting with Windows Vista, IDirectSound::GetSpeakerConfig and IDirectSound::SetSpeakerConfig have been deprecated.
When an application calls IDirectSound::SetSpeakerConfig (see Microsoft Windows SDK documentation) to change the speaker configuration, DirectSound translates the specified DSSPEAKER_Xxx speaker-configuration parameter to the equivalent KSAUDIO_Xxx channel-configuration mask. It sends a KSPROPERTY_AUDIO_CHANNEL_CONFIG set-property request containing this mask to the filter that represents the DirectSound device.
In the following table, each DSSPEAKER_Xxx parameter on the left is paired with the equivalent KSAUDIO_Xxx channel-configuration mask on the right.
| DSSPEAKER Parameter | KSAUDIO Channel-Configuration Mask |
|---|---|
DSSPEAKER_DIRECTOUT |
KSAUDIO_SPEAKER_DIRECTOUT |
DSSPEAKER_HEADPHONE |
KSAUDIO_SPEAKER_STEREO |
DSSPEAKER_MONO |
KSAUDIO_SPEAKER_MONO |
DSSPEAKER_STEREO |
KSAUDIO_SPEAKER_STEREO |
DSSPEAKER_QUAD |
KSAUDIO_SPEAKER_QUAD |
DSSPEAKER_SURROUND |
KSAUDIO_SPEAKER_SURROUND |
DSSPEAKER_5POINT1 |
KSAUDIO_SPEAKER_5POINT1 |
DSSPEAKER_7POINT1 |
KSAUDIO_SPEAKER_7POINT1 |
In the preceding table, DirectSound specifies both its headphone and stereo speaker configurations with the same channel mask, KSAUDIO_SPEAKER_STEREO. To distinguish between these two configurations, DirectSound sends the filter a second set-property request, which specifies a speaker geometry (see KSPROPERTY_AUDIO_STEREO_SPEAKER_GEOMETRY). To indicate headphones, DirectSound passes the value KSAUDIO_STEREO_SPEAKER_GEOMETRY_HEADPHONE with the speaker-geometry request.
In the case of stereo speakers, however, the caller to SetSpeakerConfig can specify one of several possible DSSPEAKER_Xxx stereo-speaker geometries. These appear in the left column of the following table, and the equivalent KSAUDIO_Xxx parameters appear on the right.
| DSSPEAKER Stereo-Speaker Geometry | KSAUDIO Stereo-Speaker Geometry |
|---|---|
DSSPEAKER_GEOMETRY_WIDE |
KSAUDIO_STEREO_SPEAKER_GEOMETRY_WIDE |
DSSPEAKER_GEOMETRY_NARROW |
KSAUDIO_STEREO_SPEAKER_GEOMETRY_NARROW |
DSSPEAKER_GEOMETRY_MIN |
KSAUDIO_STEREO_SPEAKER_GEOMETRY_MIN |
DSSPEAKER_GEOMETRY_MAX |
KSAUDIO_STEREO_SPEAKER_GEOMETRY_MAX |
If the caller does not explicitly specify one of the geometries in the left column above, DirectSound assumes DSSPEAKER_GEOMETRY_WIDE by default.