NDISTest 6.5 - WlanD2SleepBVT - OSStack

This automated test places the system in Connected Standby and validates that the system remains in a Connected Standby state.

Test details

Associated requirements	Device.Network.WLAN.Base.MeetScanAndConnReq Device.Network.WLAN.CSBBase.MeetScanAndConnReq Device.Network.WLAN.CSBWoWLAN.MustSupportWakeOnWLAN Device.Network.WLAN.WoWLAN.ImplementWakeOnWLAN See the device hardware requirements.
Platforms	Windows RT (ARM-based) Windows 8 (x64) Windows 8 (x86) Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86
Expected run time	~10 minutes
Categories	Certification Functional
Type	Automated

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: Wireless LAN (802.11) Testing Prerequisites.

The following suites are available in this test:

• PM_WLanD2Sleep

The PM_WLanD2Sleep suite consists of the following:

Name	Description
Pre-configuration	Rebind the operating system stack on the DUT and the SUT. Configure one of the access point to use WPA2/AES.
	Connect to the access point. Put the device to sleep for 2 minutes. Check the transitions. Verify the device stayed in a low power state for duration Disable and then enable the wireless adapter. Repeat 4 times.

 

Troubleshooting

For troubleshooting information, see Troubleshooting Wireless LAN (802.11) Tests.

More information

Command syntax

Parameter	Description
AP1Password	The root password for the first physical access point.
AP1IPAddress	The IP address of the WAN port of the first physical access point.
AP2Password	The root password for the second physical access point.
AP2IPAddress	The root password for the second physical access point.

 

 

 

Send comments about this topic to Microsoft