Considerations for Switching from the Full or Bulk-Logged Recovery Model
A database can be switched to another recovery model at any time. If a switch occurs during a bulk operation, the logging of the bulk operation changes accordingly.
Switching between full and bulk-logged recovery models is useful before and after large bulk operations. The full recovery model, which fully logs all transactions, is intended for normal use. The bulk-logged recovery model is intended to be used temporarily during a large bulk operation—assuming that it is among the bulk operations that are affected by the bulk-logged recovery model (for more information, see Operations That Can Be Minimally Logged). If you switch between the full and bulk-logged recovery models during a bulk operation, logging of the bulk operation changes accordingly.
Restrictions
Some features such as database mirroring require that the database remain in the full recovery model.
When transactional replication is enabled, SELECT INTO and BULK INSERT operations are fully logged even under the Bulk Logged recovery model.
Switching Between Full and Bulk-Logged Recovery
For a database that uses full recovery, switching to the bulk-logged recovery model temporarily for bulk operations improves performance. However, point-in-time recovery is not possible with bulk-logged model. Therefore, if you run transactions under the bulk-logged recovery model that might require a transaction log restore, these transactions could be exposed to data loss. To maximize data recoverability in a disaster-recovery scenario, we recommend that you switch to the bulk-logged recovery model only under the following conditions:
Users are currently not allowed in the database.
All modifications made during bulk processing are recoverable without depending on taking a log backup; for example, by re-running the bulk processes.
If you satisfy these two conditions, you will not be exposed to any data loss while restoring a transaction log that was backed up under the bulk-logged recovery model.
We recommend that:
Before switching to the bulk-logged recovery model, you back up the log.
This is important because, under the bulk-logged recovery model, if the database fails, backing up the log for bulk operations requires access to the data.
After performing the bulk operations, you immediately switch back to full recovery mode.
After switching back from the bulk-logged recovery model to the full recovery model, you back up the log again.
Following these recommendations fully protects your data and enables point-in-time recovery. The following figure illustrates these recommendations.
.gif "Recommend process for using bulk-logged recovery")
When switching between two recovery models, your backup strategy remains the same: continue performing periodic database, log, and differential backups.
Switching from Full or Bulk-Logged to Simple Recovery
Switching from the full or bulk-logged recovery to simple recovery is possible, but uncommon.
Back up the transaction log just before switching to the simple recovery model, to permit recovery to that point. Backing up the log is not supported under the simple recovery model, so, after switching, discontinue any scheduled jobs for backing up the transaction log. For more information, see How to: Change Maintenance Tasks in the Maintenance Plan Wizard.
Changing the Recovery Model
To change the recovery model (Transact-SQL)
Use ALTER DATABASE, as follows:
To set the database to the full recovery model:
USE master;
ALTER DATABASE database_name SET RECOVERY FULL;
To set the database to the bulk-logged recovery model:
USE master;
ALTER DATABASE database_name SET RECOVERY BULK_LOGGED;
Note
To change the default recovery model for new databases, use ALTER DATABASE to change the recovery model of the model database.
To change the recovery model (SQL Server Management Studio)