Remove-Label

Reference

Module:: ExchangePowerShell

Applies to:: Security & Compliance

This cmdlet is available only in Security & Compliance PowerShell. For more information, see Security & Compliance PowerShell.

Use the Remove-Label cmdlet to remove sensitivity labels from your organization.

For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.

Syntax

Remove-Label
      [-Identity] <ComplianceRuleIdParameter>
      [-Confirm]
      [-WhatIf]
      [<CommonParameters>]

Description

To use this cmdlet in Security & Compliance PowerShell, you need to be assigned permissions. For more information, see Permissions in the Microsoft Purview compliance portal.

Examples

Example 1

Remove-Label -Identity "Marketing Group"

This example removes the sensitivity label named Marketing Group.

Parameters

-Confirm

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.
Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.

Type:	SwitchParameter
Aliases:	cf
Position:	Named
Default value:	None
Required:	False
Accept pipeline input:	False
Accept wildcard characters:	False
Applies to:	Security & Compliance

-Identity

The Identity parameter specifies the sensitivity label that you want to remove. You can use any value that uniquely identifies the label. For example:

Name
Distinguished name (DN)
GUID

Type:	PolicyIdParameter
Position:	1
Default value:	None
Required:	True
Accept pipeline input:	True
Accept wildcard characters:	False
Applies to:	Security & Compliance

-WhatIf

The WhatIf switch causes the command to simulate its results. By using this switch, you can view what changes would occur without having to commit those changes.

Type:	SwitchParameter
Aliases:	wi
Position:	Named
Default value:	None
Required:	False
Accept pipeline input:	False
Accept wildcard characters:	False
Applies to:	Security & Compliance

Delen via