Netsh commands for Interface ISATAP
Applies To: Windows Server 2008
This section contains the following commands.
set router
set state
show router
show state
Interface ISATAP commands
The following entries provide details for each command.
set router
Sets Intra-site Automatic Tunnel Address Protocol ISATAP router information.
Syntax
set router [ [ name= ] (Name | default )] [ [ state= ] ( enabled | disabled | default ) ] [[interval=] Interval ]
Parameters
- name
Optional. Specifies the name of the ISATAP router.
- state
Optional. Specifies the state of router name resolution.
- interval
Optional. Specifies an integer that is the resolution interval (in minutes).
Examples
Following is an example of the set router command.
set router isatap enabled 1440
set state
Sets the ISATAP state.
Syntax
set state [ state= ] ( enabled | disabled | default)
Parameters
- state
Optional. Specifies whether ISATAP is enabled.
show router
Shows the ISATAP router information.
Syntax
show router
show state
Shows the ISATAP state.
Syntax
show state