다음을 통해 공유


NEC Solution Gear 2-Vr5500 Development Kit Supported Features (Windows CE 5.0)

Send Feedback

The following table shows the hardware components that are supported in the board support package (BSP) for the NEC Solution Gear 2-Vr5500 Development Kit for Vr5432/5500 microprocessors.

Hardware component Solution Gear 2-Vr5500 hardware support Solution Gear 2-Vr5500 BSP support
RAM 128 MB RAM image
Flash 32 MB Intel DA28F640J5 Yes
Boot ROM 512 KB Not applicable
Timers 2 Yes
Real-time clock Yes Yes
VGA PCI card All supported PCI video cards
LCD Yes Yes
Ethernet Built-in AMD AM79C973 Debug and Product Ethernet through all supported PCI Ethernet cards
Serial 2 Yes. The top one is for debug messages and the bottom one is for product serial.
PCMCIA or CF PCI card TI1250
Mouse PS/2 Yes
Keyboard PS/2 Yes
Hardware reset through a cold boot Yes Yes
Hardware reset through a warm boot Yes Yes
Software reset through a warm boot Not applicable Yes
Touch controller No No
Universal serial bus (USB) host PCI card and built-in OHCI controller Yes
USB function PCI card (Netchip 2890) Yes
Serial Infrared (SIR) Yes Yes
Fast Infrared (FIR) Yes No
Audio output PCI card Yes
Audio input PCI card Yes
Parallel port for printing 1 Yes
Integrated Device Electronics (IDE) 1 Hard disk drives (HDDs) only, no CD-ROM drives
Smart card USB and PCMCIA Readers Not tested
IEEE 1394 PCI card Yes
Floppy disk No No
TV output PCI card Yes
Floating point unit Yes Yes
Expansion connector PCI and compact PCI Yes
PCI slots 4 Yes
Compact PCI or PCI extender Both (Use PCI4 slot for extender) Yes
Logic analyzer probes Yes Yes
IEEE 1149.1-compliant (JTAG) Yes Yes
Debug LEDs Yes One digit
Companion or add-on cards Vr5432/Vr5500 companion Yes
Form factor Custom Not applicable

NEC Solution Gear 2-Vr5500 Development Kit Hardware Restrictions and Limitations

Keep in mind the following NEC Solution Gear 2-Vr5500 Development Kit restrictions and limitations:

  • The PCI INTC routed through the ALI M1535+ chip on the baseboard does not work properly. The PCI card using this interrupt will not work. This situation occurs only with a special card or when the PCI extension box is used, because the interrupt is not attached to the PCI INTA signal on a baseboard PCI slot.

See Also

Setting up the NEC Solution Gear 2-Vr5500 Development Kit Hardware | How to Use the BSP for the NEC Solution Gear 2-Vr5500 Development Kit

Send Feedback on this topic to the authors

Feedback FAQs

© 2006 Microsoft Corporation. All rights reserved.