Creating the Boot Loader .bib File (Windows CE 5.0)

아티클
09/14/2012

The .bib file details the memory layout that the boot loader will use. Romimage.exe uses this file to convert the boot loader executable (.exe) file into .bin and .nb0 files.

For more information about .bib files, see Binary Image Builder File.

For more information about Romimage.exe, see Romimage.

For more information about the Windows CE memory, see Memory Architecture.

To create the boot loader BIB file

In %_WINCEROOT%\Platform\MyPlatform\Src\Bootloader\Eboot, create a file called Boot.bib.

Add the following configuration information to the Boot.bib file.

; Eboot is built to run out of RAM, though initially the location of the 
; image may be in flash.  This .bib file will create two different Eboot 
; images of interest:
;
; Eboot.nb0 - Can be used to flash an initial Eboot image using JTAG.
; Eboot.bin - Can be downloaded by existing Eboot image and flashed.
;
; Note: The .nb0 file is a raw binary image. The .bin file is a recordized
; image with header.
;

MEMORY
;   Name     Start     Size      Type
;   -------  --------  --------  ----

    ; Reserve some RAM before Eboot.
    ; This memory will be used later.

    FILLER   A0000000  00030000  RESERVED   ; Replaced with data later.

    EBOOT    A0030000  00020000  RAMIMAGE   ; Set aside 128 KB for loader; finalize later.
    RAM      A0050000  00010000  RAM        ; Free RAM; finalize later.

CONFIG
    COMPRESSION=OFF
    PROFILE=OFF
    KERNELFIXUPS=ON

    ; These configuration options cause the .nb0 file to be created. 
    ; An .nb0 file may be directly written to flash memory and then 
    ; booted. Because the loader is linked to execute from RAM, 
    ; the following configuration options 
    ; must match the RAMIMAGE section.
    ROMSTART=A0030000
    ROMWIDTH=32
    ROMSIZE=20000

MODULES
;   Name         Path                                          Memory Type
;   -----------  --------------------------------------------- -----------
    nk.exe       $(_TARGETPLATROOT)\target\$(_TGTCPU)\$(WINCEDEBUG)\EBOOT.exe   EBOOT

The previous configuration information specifies the following boot loader properties:

Running with the MMU off; thus, the addresses are physical.
Running from RAM; thus, the RAMIMAGE line specifies a RAM address.

The lengths specified in the boot loader image and the RAM used by the boot loader image are somewhat arbitrary. The values can be adjusted throughout the development process to more optimal values once the boot loader is completed.

For more information about the MEMORY section in the preceding configuration example, see MEMORY Section.

For more information about the MODULES section in the preceding configuration example, see MODULES Section.

For more information about the CONFIG section in the preceding configuration example, see CONFIG Section.

In %_WINCEROOT%\Platform\MyPlatform\Src\Bootloader\Eboot, create a file called Makefile.inc.
Add the following code to the Makefile.inc file.
```
BootImage:
     romimage  boot.bib
```
Edit the sources file by adding the following code to the end of the sources file.
```
WINCETARGETFILES=BootImage
```

다음을 통해 공유

Creating the Boot Loader .bib File (Windows CE 5.0)

See Also

추가 리소스