다음을 통해 공유

Publishing SharePoint Using UAG – Trips and Tricks

  • 아티클

 

Hello Folks,

I am starting this blog with Two Assumptions,

You have already created a Trunk in UAG and have a SharePoint site which you are trying to publish.

In the below post I am mainly explaining the steps using which you can publish a SharePoint site without using an external DNS entry.

In this case, I have a web application named HRWeb and have created a portal trunk.

clip_image002

From the UAG Portal, as you can see below, run the application wizard to add the application

clip_image004

Once it reaches the Select Application step, chose Web ‘Other web application (Portal Hostname) ’

clip_image006

If you are publishing a generic application mention the Application name and the Application type.

clip_image007

In next step I am choosing the default END point policies except the Access policy as “Always”

clip_image009

In the next step, I will choose Configure an application server as the option, as I have only one SharePoint server in my test LAB and I don’t have to use UAG Load Balancing.

.clip_image011

In the next section, I can either provide a Host header or IP address of the SharePoint site, in this case Hrweb.spf.com as the host header.

clip_image012

Check the Add portal and tool bar link and also check the open in new window option as well.

clip_image013

We will choose to authorize all users.

 

clip_image014

Add the Authentication source as a Domain controller DC.SPF.com as the source is AD users

clip_image015

clip_image016

Once you have completed the ADD application wizard, in the next step we will need to activate configuration. This essentially publishes the application.

clip_image018

After publishing, once you login to the UAG portal, you will be able to find the Application as shown below.

clip_image020

Try accessing the HRWEB SharePoint site and please check the URL of the HRweb site that is published. It uses a relative URL.

clip_image022

Hope that helps..!!!!!!

Please feel free to provide any feedback or if you have any questions just use Send email to author to contact me.

Comments

  • Anonymous
    April 16, 2014
    Thanks for the detailed screenshots which were helpful - I wish the scenario were described a bit more.