次の方法で共有


Activating a VC (NDIS 5.1)

Note   NDIS 5. x has been deprecated and is superseded by NDIS 6. x. For new NDIS driver development, see Network Drivers Starting with Windows Vista. For information about porting NDIS 5. x drivers to NDIS 6. x, see Porting NDIS 5.x Drivers to NDIS 6.0.

After a virtual connection (VC) has been created (see Creating a VC), it must be activated before data can be transmitted and/or received on it. A call manager initiates the activation of a VC by calling NdisCmActivateVc(see the following figure).

An MCM driver initiates the activation of a VC by calling NdisMCmActivateVC(see the following figure).

A call manager or MCM driver could initiate reactivation of an active VC if the local client or a remote party successfully negotiates a change in call parameters on that VC (see Client-Initiated Request to Close a Calland Incoming Request to Change Call Parameters). The call manager or MCM driver can call Ndis(M)CmActivateVc many times for a single VC to change the call parameters for an already active call.

For a client-initiated outgoing call, a call manager or an MCM driver usually calls Ndis(M)CmActivateVc immediately following the packet exchange confirming a negotiated agreement with the remote target of the call or successful call-setup at the switch. The call manager or MCM driver calls Ndis(M)CmActivateVc before it notifies NDIS (and the client) of outgoing call completion with Ndis(M)CmMakeCallComplete (see Making a Call). For an incoming call, a call manager or MCM driver usually calls Ndis(M)CmActivateVc after it has called NdisCo(MCm)CreateVc successfully and before it calls Ndis(M)CmDispatchIncomingCall (see Indicating an Incoming Call).

A call manager's call to NdisCmActivateVccauses NDIS to call the MiniportCoActivateVc function of the underlying miniport driver. MiniportCoActivateVc must validate the call parameters for this VC to verify that the adapter can support the requested call. If the call parameters are acceptable, MiniportCoActivateVc communicates with its adapter as necessary to prepare the adapter to receive or transmit data across the virtual connection (for example, programming receive buffers). If the requested call parameters cannot be supported, the miniport driver fails the request.

MiniportCoActivateVc can complete synchronously or asynchronously. The call to NdisMCoActivateVcComplete. causes NDIS to call the call manager's ProtocolCmActivateVcComplete function. ProtocolCmActivateVcComplete must check the status returned by NdisMCoActivateVcComplete to ensure that the virtual connection has been activated successfully. If the miniport driver did not successfully activate the VC, the call manager must not attempt to communicate over the VC. ProtocolCmActivateVcComplete must also complete any processing required by the network media to ensure that the virtual connection is ready for data transmission before returning control to NDIS.

An MCM driver's call to NdisMCmActivateVc informs NDIS that it has set up call and media parameters on a newly created VC or changed the call parameters on an established VC. This notifies NDIS that the MCM driver has made its NIC ready for transfers on the VC. NDIS completes the activation sequence by calling the MCM driver's ProtocolCmActivateVcComplete function.

An MCM driver calls NdisMCmActivateVc to activate only VCs used for transmitting and/or receiving client data, but not to activate VCs used for exchanging signaling messages between the MCM driver and network components such as a switch. An MCM driver activates a signaling VC internally without calling any NdisXxx function. Any VC that an MCM driver sets up for its own signaling purposes is therefore opaque to NDIS.

 

 

Send comments about this topic to Microsoft