Fax Modem INF File Entries
This section describes the modem setup information (INF) file entries that create registry values under the Fax subkey, to configure fax modem features.
In this section
| Topic | Description |
|---|---|
The ExitCommand entry identifies the command string that is issued to the modem after hang-up, and just before Unimodem releases the port. |
|
The PreAnswerCommand entry identifies the modem command string that is issued to the modem just before Unimodem issues the ATA command. |
|
The PreDialCommand entry specifies the modem command string that is issued to the modem just before Unimodem issues the ATD command. |
|
The ResetCommand entry identifies the command string that is sent before every send and before every answer. |
|
The SetupCommand entry identifies the AT command that is sent before every send operation and before every answer operation (after the reset command). |
|
The EnableV17Recv entry identifies the command that disables the use of V.17 during a FAX call. |
|
The EnableV17Send entry identifies the command that enables the use of V.17 during a FAX call. |
|
The FixModemClass entry specifies the preferred fax class. |
|
The FixSerialSpeed entry specifies the DTE-DCE baud rate to be used when the modem is in Class1 or Class2 mode. |
|
The HighestSendSpeed entry specifies the highest over-the-wire speed acceptable for sending a fax, in bits per second. |
|
The LowestSendSpeed entry specifies the lowest over-the-wire speed that is acceptable for sending a fax, in bits per second. |
|
The fax settings have been set up as a hierarchical Fax Registry tree with INF file entries defining the modem state. |
|
This section describes modem INF file entries for Class 1 Fax modems. |
|
The Microsoft Fax Class2 driver uses an internal table to identify modem-specific behavior. However, the table entries can be overridden by specifying the corresponding entries in the modem's INF file. |