次の方法で共有


USB Host Driver Verification Tests (Compact 2013)

3/26/2014

The USB Host-Controller Driver test verifies basic functionality of the USB host-controller driver. It can also be used to determine whether a given USB host-controller, either stand-alone or on-board logic, works correctly with Windows Embedded Compact.

Test Prerequisites

Your device must meet the following requirements before you run this test.

Hardware Requirements:

* The platform under test must have an onboard host-controller or a connected host-controller card.

Software Requirements for the USB Host Driver Verification Test are shown in the following table:

Requirement

Description

Tux.exe

Test harness, required for executing the test.

KTux.dll

Test harness module, required for executing kernel-mode tests.

Kato.dll

Logging engine, required for logging the test data.

usbhostbvt.dll

Library containing the test code, loaded by the Tux test harness.

Subtests

The table below lists the subtests included in this test.

SubTest ID

Description

100

Get USBD Version Test.

This test gets the USB driver version using a helper function.

101

Register Client Test.

This test registers a client driver.

102

Registry Test for Registered Client.

This test verifies the registry of a client driver.

103

Open Registry Test for Registered Client.

This test verifies opening the registry of client driver.

104

Get Client Registry Path for Registered Client Test.

This test registers the client and checks the registry path.

105

Unregister Client Test.

This test unregisters a client driver.

106

Registry Test for Unregistered Client.

This test verifies the registry of a unloaded/non-existent client driver.

107

Open Registry Test for UnRegistered Client.

This test unregisters the client driver and tries to open the registry for an unloaded/non-existent client.

108

Get Client Registry Path for UnRegistered Client Test.

This test unregisters the client driver and checks the registry path for the unloaded/non-existent client.

200

Suspend/Resume Get USBD Version Test

This is an optional test. If enabled, this test ensures Current and Default client are correct after a suspend/resume cycle.

If not enabled via the command line, it will simply skip.

201

Suspend/Resume Registered Client Test

This is an optional test. If enabled, this test ensures Current and Default client are correct after a suspend/resume cycle.

If not enabled via the command line, it will simply skip.

202

Suspend/Resume UnRegistered Client Test

This is an optional test. If enabled, this test ensures Current and Default client are correct after a suspend/resume cycle.

If not enabled via the command line, it will simply skip.

Setting Up the Test

This test has no additional requirements, beyond the standard test environment setup.

Running the Test

By default, the USB Host Driver Verification Tests executes: "tux -o -n -d usbhostbvt".

The following table shows the command line parameter for the USB Host Driver Verification Test.

Command line parameter

Description

-c "-s"

Enables Suspend/Resume for USB Function Driver Verification tests. This command line parameter enables Test IDs 200-202.

Verifying the Test

When the test completes running, verify that "PASSED" appears in the test log for all sub-tests.

Troubleshooting the Test

* Determine the point of failure and record the exact error message.

* If the source code is available, examine the point of failure in code to see if any additional information can be gathered about the failure domain.

See Also

Other Resources

USB - Host Tests