Condividi tramite

RIP for IP

  • Articolo

Applies To: Windows Server 2003, Windows Server 2003 R2, Windows Server 2003 with SP1, Windows Server 2003 with SP2

RIP for IP

The Routing Information Protocol (RIP) is designed for exchanging routing information within a small to medium-size internetwork.

The biggest advantage of RIP is that it is extremely simple to configure and deploy. The biggest disadvantage of RIP is its inability to scale to large or very large internetworks. The maximum hop count used by RIP routers is 15. Networks that are 16 hops or more away are considered unreachable. As internetworks grow larger in size, the periodic announcements by each RIP router can cause excessive traffic. Another disadvantage of RIP is its high recovery time. When the internetwork topology changes, it may take several minutes before the RIP routers reconfigure themselves to the new internetwork topology. While the internetwork reconfigures itself, routing loops may form that result in lost or undeliverable data.

Initially, the routing table for each router includes only the networks that are physically connected. A RIP router periodically sends announcements that contain its routing table entries to inform other local RIP routers of the networks it can reach. RIP version 1 uses IP broadcast packets for its announcements. RIP version 2 uses multicast or broadcast packets for its announcements.

RIP routers can also communicate routing information through triggered updates. Triggered updates occur when the network topology changes and updated routing information is sent that reflects those changes. With triggered updates, the update is sent immediately rather than waiting for the next periodic announcement. For example, when a router detects a link or router failure, it updates its own routing table and sends updated routes. Each router that receives the triggered update modifies its own routing table and propagates the change.

Routing and Remote Access supports RIP versions 1 and 2. RIP version 2 supports multicast announcements, simple password authentication, and more flexibility in subnetted and Classless InterDomain Routing (CIDR) environments.

The Windows Server 2003 family implementation of RIP has the following features:

  • Selection of which RIP version to run on each interface for incoming and outgoing packets.

  • Split-horizon, poison-reverse, and triggered-update algorithms that are used to avoid routing loops and speed recovery of the internetwork when topology changes occur.

  • Route filters for choosing which networks to announce or accept.

  • Peer filters for choosing which router's announcements are accepted.

  • Configurable announcement and route aging timers.

  • Simple password authentication support.

  • The ability to disable subnet summarization.

For information about designing and deploying a RIP-for-IP internetwork, see Setting Up a RIP-for-IP Routed Internetwork.

For detailed information about the operation of RIP for IP, see "Unicast IP Routing" at the Microsoft Windows Resource Kits Web site.

Note

  • If you are using multiple IP routing protocols, configure only a single routing protocol per interface.