Partager via

NDISTest 6.5 - 2 Machine - QosPriorityFlowControl

  • Article

This test validates PFC in accordance with IEEE specification and the disparity between CEE and IEEE PFC configuration specification may result in test failures if this requirement is not met.

Adapter Configuration: DUT - QOS capable adapter SUT - Network adapter capable of working at DUT's line rate.

Test Cases:

  • CheckConnectivity: Ensures that the m_Dut and m_Sut can send and receive traffic respectively and the bandwidth monitor is able to see the traffic received at m_Sut PFC Control Frame is sent with.

  • PriorityEnableVector: Set to zero

  • Time[all elements] -: Set to zero

  • TestPfc: Ensures that m_Dut Responds to PFC Frames by Pausing Traffic Fabricate PFC MAC Control Frame with - - Correct Bit Set on Priority Enable Vector - Max quanta value in Time Vector

  • TestPfcDisabled: Ensures that m_Dut does Not Respond to PFC Frames when PFC is Disabled Fabricate PFC MAC Control Frame with - - Correct Bit Set on Priority Enable Vector - Max quanta value in Time Vector

  • TestPfcPriorityEnableVectorBitsReset: Ensures that m_Dut does Not Pause Traffic for PFC Frames with All Priority Enable Vector Bits Reset Fabricate PFC MAC Control Frame with - - All Priority Enable Vector Bits Reset - Max quanta value in Time Vector for Correct Priorities

  • TestPfcTimeVectorZeroQuanta: Ensures that m_Dut does Not Respond to PFC Frames All Time vector entries Set to Zero Quanta Fabricate PFC MAC Control Frame with - - Correct Priority Enable Vector Bits Set - All Zero quanta values in all Time Vector entries

Test details

Associated requirements

Device.Network.LAN.DCB.DCB

See the device hardware requirements.

Platforms

Windows Server 2012 (x64) Windows Server 2012 R2

Expected run time

~10 minutes

Categories

Certification Functional

Type

Automated

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: LAN Testing Prerequisites.

Troubleshooting

For troubleshooting information, see Troubleshooting LAN Testing.

If the device under test follows CEE specific DCBX PFC configuration, ensure that DCBX is turned off on the system under test before running this test or replace the system under test with a non-DCB capable adapter.

 

 

Send comments about this topic to Microsoft