WiFi Direct Performance Test JoinExistingGO WFDPlatform
This test suite verifies WFD pairing while the DUT and the SUT are in varying states of access point connectivity.
Test details
Associated requirements |
Device.Network.WLAN.CSBWiFiDirect.SupportAtLeast2WiFiDirectPortsConcurrently Device.Network.WLAN.CSBWiFiDirect.SupportAtLeast4Clients Device.Network.WLAN.WiFiDirect.SupportAtLeast2WiFiDirectPortsConcurrently Device.Network.WLAN.WiFiDirect.SupportAtLeast4Clients |
Platforms |
Windows RT (ARM-based) Windows 8 (x64) Windows 8 (x86) Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86 |
Expected run time |
~20 minutes |
Categories |
Certification Reliability |
Type |
Automated |
Running the test
Before you run the test, complete the test setup as described in the test requirements: Wireless LAN (802.11) Testing Prerequisites.
This test suite does the following:
The SUT acts as a listener and the DUT connect to it.
Verify that the pairing was completed in 3 seconds on the connector side and 25 seconds on the listener side.
Verify that packet loss for simultaneous pings between the STA and the access point and the GO and the client is less than 95%.
Verify that average latency is less than 500 milliseconds.
These tests are driven at the Proximity (Peerfinder) RT layer for GO Negotiation and Invitation and the WLanAPI layer for JoinExistingGO.
Troubleshooting
For troubleshooting information, see Troubleshooting Wireless LAN (802.11) Tests.
More information
Command syntax
| Parameter | Description |
|---|---|
APPID |
APPID Unique APPID to use. Example: WFDPerfTests |
AP1Password |
The root password for the first physical access point. |
AP1IPAddress |
The IP address of the WAN port of the first physical access point. |
AP2Password |
The root password for the second physical access point. |
AP2IPAddress |
The root password for the second physical access point. |
AP1Channel |
The wireless channel configured on the first access point. |
AP2Channel |
The wireless channel configured on the second access point. |