TCP/IP Best Practices (Windows CE 5.0)
This section provides general best practices for TCP/IP. For security-specific best practices, see TCP/IP Security.
Make sure to preserve the multicast membership for PCMCIA adapters
When a device resumes from a suspended state, the network adapters are unloaded and then reloaded. The multicast membership is preserved for PCI adapters. However, for PCMCIA adapters, you must set ResetOnResume in the registry to preserve the multicast membership. For more information about this registry setting, see TCP/IPv4 and TCP/IPv6 Common Registry Settings.
To conserve battery power, configure a device to suspend automatically
By default, the following conditions prevent a Windows CE-based device from automatic suspension due to inactivity:
- Connected TCP sockets, including loopback
- Connected IR sockets
- Active network adapters
- An established PPP connection
You can use the NoIdleIfAdapter and NoIdleIfConnected registry values to configure a device to suspend automatically after a certain period of inactivity. For more information, see TCP/IPv4 Configurable Registry Settings.
You can also use the following registry values to configure a device to suspend automatically after an inactive period:
HKEY_LOCAL_MACHINE_Comm\Parms\AllowSuspend
Default setting is 0 (False). Setting this value to 1 (True) allows the device to auto-suspend while a PPP section is active.
HKEY_LOCAL_MACHINE\Comm\IrDA\AutoSuspend
Default setting is 0 (False). Setting this value to 1 allows the device to idle-suspend when active IR sockets are open.
Note The registry settings that affect device suspension are global and are read when the device is initialized. If you change these settings, you must reset the device before the new settings take effect.
For more information, see Power Management, TCP/IPv4 Configurable Registry Settings, and Dial-up Registry Settings.
See Also
Send Feedback on this topic to the authors