Partager via

LINE_LINEDEVSTATE (TSPI) (Compact 2013)

  • Article

3/26/2014

This message is sent to the LINEEVENT callback function when the state of a line device has changed. TAPI can invoke TSPI_lineGetLineDevStatus to determine the new status of the line.

Syntax

LINE_LINEDEVSTATE
    htLine = (HTAPILINE) hLineDevice;
    htCall = (HTAPICALL) 0;
    dwMsg = (DWORD) LINE_LINEDEVSTATE;
    dwParam1 = (DWORD) LineDevState;
    dwParam2 = (DWORD) DevStateData1;
    dwParam3 = (DWORD) DevStateData2;

Parameters

  • htLine
    The TAPI opaque object handle to the line device.
  • htCall
    Not used.

  • dwMsg
    The value LINE_LINEDEVSTATE.

    Specifies the callback instance supplied when opening the line.

  • dwParam1
    Specifies the line device status item that has changed. This parameter uses one or more of the LINEDEVSTATE_ constants.
  • dwParam2
    The interpretation of this parameter depends on the value of dwParam1. If dwParam1 is LINEDEVSTATE_RINGING, dwParam2 contains the ring mode with which the switch instructs the line to ring. Valid ring modes are numbers in the range one to dwNumRingModes, where dwNumRingModes is a line device capability.
  • dwParam3
    The interpretation of this parameter depends on the value of dwParam1. If dwParam1 is LINEDEVSTATE_RINGING, dwParam3 contains the ring count for this ring event. The ring count starts at zero.

Remarks

The sending of this message can be controlled through TSPI_lineSetStatusMessages. The service provider must send LINE_LINEDEVSTATE messages for at least the set of status changes selected through that procedure. The service provider can send more than this set, however, it should try to limit its messages to this set for performance reasons. By default all status reporting is disabled.

At the TSPI level, the service provider does not report state changes when the line is opened and closed, since there is only ever one Open outstanding for the device.

For backward compatibility, older service providers would not be expected to generate these values. If they do, TAPI treats them the same as if the service provider were using API version 1.4 or later (as described earlier).

Requirements

Header

tspi.h

See Also

Reference

TSPI Messages
LINEEVENT
TSPI_lineGetLineDevStatus
TSPI_lineSetStatusMessages