Partager via

Configuration of Non-Plug and Play Serial Device Connected to an RS-232 Port

  • Article

This topic describes the typical configuration of hardware, drivers, and device stacks for legacy serial devices that are connected to an RS-232 port.

The following diagram shows the typical configuration for a non-Plug and Play Toaster device.

Diagram illustrating hardware and drivers-and-device-stacks configurations for a non-Plug and Play toaster device

Serenum is not used to install a non-Plug and Play serial device. The installation of the Toaster device stack is device-specific. To communicate with the Toaster device, the Toaster driver opens the COM port that is associated with the RS-232 port.

 

 

Send comments about this topic to Microsoft