Partager via

Enumerating Audio Types for Specific Encoding Modes

  • Article

The input and output media types accepted by the audio encoder are very structured. You must obtain supported output types by calling IMediaObject::GetOutputType method or IMFTransform::GetOutputType. After you get an output type, you must not alter it.

If you want to use an encoding mode other than one-pass CBR, you must set the mode and then enumerate the output types for that mode; the encoder changes the supported output types depending upon the mode set. The properties that control the encoding mode are MFPKEY_VBRENABLED and MFPKEY_PASSESUSED. When the mode is set in the encoder, you must enumerate and select an output type, using it without alteration, just as with CBR.

Identifying Quality Based VBR Types

The procedure for identifying quality based VBR types depends on whether the encoder is acting as a DirectX Media Object (DMO) or acting as a Media Foundation Transform (MFT). For information on when an encoder acts as a DMO or an MFT, see the individual codec reference pages under Codec Objects.

When an audio encoder is acting as a DMO and you configure the encoder to use one-pass VBR, it enumerates all of the supported output types. However, you will typically want to select a one-pass VBR type based on the quality parameter. The encoder puts the quality value for one-pass VBR output types in the nAvgBytesPerSec member of the WAVEFORMATEX structure pointed to by DMO_MEDIA_TYPE.pbFormat.

This value is stored in the following format: 0x7FFFFFXX, where XX is the quality value (from 0 to 100). For example, the nAvgBytesPerSec value of 0x7FFFFF62 specifies quality level 98 (0x62 = 98).

The following example shows how to check the quality level of a format when the encoder is acting as a DMO.

void ShowQuality(WAVEFORMATEX* pWave)
{
    // Store the average bytes per second in a local variable
    // with a more manageable name.
    DWORD dwBps = pWave->nAvgBytesPerSec;

    // Verify that the value is a VBR quality level by using 
    // a bitmask to check for the bit pattern 0x7FFFFFXX. 
    if(dwBps & 0x7FFFFF00 == 0x7FFFFF00)
        printf("VBR Quality: %d%%\n",(dwBps & 0x000000FF));
    else // Not a valid VBR quality value.
        printf("Not a valid one-pass VBR audio format.\n");
}

When the encoder is acting as an MFT and it enumerates an output type on a call to GetAvailableOutputType, you can query the MFT for the MFPKEY_MOST_RECENTLY_ENUMERATED_VBRQUALITY property. The value returned indicates the VBR quality of the most recently returned output media type. Then you can use that value to set the MFPKEY_DESIRED_VBRQUALITY property of the encoder.

Setting Peak Constraints

For quality based VBR (one-pass) and unconstrained two-pass VBR, no additional settings are required after retrieving the output type. To use peak-constrained VBR, retrieve an output type with VBR enabled and two passes set. This type, without alteration, describes unconstrained VBR settings. To set peak constraints, set the MFPKEY_RMAX and MFPKEY_BMAX properties.

See Also

Finding Audio Encoder Output Types

Using Two-Pass Encoding

Using VBR Encoding

 

 

Send comments about this topic to Microsoft

Build date: 4/7/2010