Muokkaa

Jaa

ADVERTISE property

  • Artikkeli

The value of the ADVERTISE property is a list of features delimited by commas that are to be advertised. The features must be present in the Feature column of the Feature table. To install all features as advertised, use ADVERTISE=ALL on the command line. Do not enter ADVERTISE=ALL into the Property table because this generates an advertised package that cannot be installed or removed.

Remarks

Note that feature names are case-sensitive.

The installer always evaluates the following properties in the following order.

  1. ADDLOCAL
  2. REMOVE
  3. ADDSOURCE
  4. ADDDEFAULT
  5. REINSTALL
  6. ADVERTISE
  7. COMPADDLOCAL
  8. COMPADDSOURCE
  9. COMPADDDEFAULT
  10. FILEADDLOCAL
  11. FILEADDSOURCE
  12. FILEADDDEFAULT

For example, if the command line specifies: ADDLOCAL=ALL, ADDSOURCE = MyFeature, all the features are first set to run-local and then MyFeature is set to run-from-source. If the command line is: ADDSOURCE=ALL, ADDLOCAL=MyFeature, first MyFeature is set to run-local, and then when ADDSOURCE=ALL is evaluated, all features (including MyFeature) are reset to run-from-source.

The installer sets the Preselected property to a value of "1" during the resumption of a suspended installation or when any of the above properties are specified on the command line.

Requirements

Requirement Value
Version
 Windows Installer 5.0 on Windows Server 2012, Windows 8, Windows Server 2008 R2 or Windows 7. Windows Installer 4.0 or Windows Installer 4.5 on Windows Server 2008 or Windows Vista. Windows Installer on Windows Server 2003 or Windows XP. See the Windows Installer Run-Time Requirements for information about the minimum Windows service pack that is required by a Windows Installer version.

See also

Properties