Deploy hyperconverged infrastructure with Windows Admin Center
You can use Windows Admin Center version 1910 or later to deploy hyperconverged infrastructure using two or more suitable Windows Servers. This new feature takes the form of a multi-stage workflow that guides you through installing features, configuring networking, creating the cluster, and deploying Storage Spaces Direct and/or software-defined networking (SDN) if selected.
As of Windows Admin Center version 2007, Windows Admin Center supports the Azure Stack HCI OS. Read about how to deploy a cluster in Windows Admin Center in the Azure Local docs. Although this documentation is focused on Azure Local, the instructions are also mostly applicable to Windows Server deployments.
Undo and start over
Use these Windows PowerShell cmdlets to undo changes made by the workflow and start over.
Remove virtual machines or other clustered resources
If you created any virtual machines or other clustered resources, such as the network controllers for software-defined networking, remove them first.
For example, to remove resources by name, use:
Get-ClusterResource -Name "<NAME>" | Remove-ClusterResource
Undo the Storage steps
If you enabled Storage Spaces Direct, disable it with this script:
Warning
These cmdlets permanently delete any data in Storage Spaces Direct volumes. This can't be undone.
Get-VirtualDisk | Remove-VirtualDisk
Get-StoragePool -IsPrimordial $False | Remove-StoragePool
Disable-ClusterS2D
Undo the Clustering steps
If you created a cluster, remove it with this cmdlet:
Remove-Cluster -CleanUpAD
To also remove cluster validation reports, run this cmdlet on every server that was part of the cluster:
Get-ChildItem C:\Windows\cluster\Reports\ | Remove-Item
Undo the Networking steps
Run these cmdlets on every server that was part of the cluster.
If you created a Hyper-V virtual switch:
Get-VMSwitch | Remove-VMSwitch
Note
The Remove-VMSwitch cmdlet automatically removes any virtual adapters and undoes switch-embedded teaming of physical adapters.
If you modified network adapter properties such as name, IPv4 address, and VLAN ID:
Warning
These cmdlets remove network adapter names and IP addresses. Make sure you have the information you need to connect afterward, such as an adapter for management that is excluded from the script below. Also make sure that you know how the servers are connected in terms of physical properties like MAC Address, not just the adapter's name in Windows.
Get-NetAdapter | Where Name -Ne "Management" | Rename-NetAdapter -NewName $(Get-Random)
Get-NetAdapter | Where Name -Ne "Management" | Get-NetIPAddress -ErrorAction SilentlyContinue | Where AddressFamily -Eq IPv4 | Remove-NetIPAddress
Get-NetAdapter | Where Name -Ne "Management" | Set-NetAdapter -VlanID 0
You're now ready to start the workflow.