Muokkaa

Jaa

Step 4: Create the Receive Port for Accepting ADT Query Messages

  • Artikkeli

You create a receive port to specify the location for incoming query messages sent by the Admissions, Discharge, and Transfer (ADT) system. Use the following procedure to create the receive port for accepting queries (QRY^Q01 messages) from the ADT system using the Minimal Lower Layer Protocol (MLLP) adapter.

Create the ADT_ReceivePort receive port

  1. Open BizTalk Server Administration, expand BizTalk Server Administration, expand BizTalk Group, expand Applications, and then expand BizTalk Application 1.

  2. Right-click Receive Ports, select New, and then select Request Response Receive Port.

  3. For the Name, enter ADT_ReceivePort.

  4. Select Apply to bind the port, and then select Receive Locations.

  5. Select New.

  6. For the Name, enter ADT_Receive.

  7. In the Transport section, select Type, and then select MLLP from the drop-down list.

  8. Select Configure. In MLLP Transport Properties, configure the following, and then select OK.

    Use this To do this
    Connect retry time (sec) New starting with BizTalk Server 2016.

    The upper limit of time to wait before attempting to reconnect a dropped or closed connection. Applicable when Connection Initiated by is set to Local.

    Default is 20 seconds.
    Connection initiated by New starting with BizTalk Server 2016.

    Enter Local for the MLLP receive location to initiate the connection to a remote LOB server. This is the new option.

    Enter Remote for the MLLP receive location to continue to listen for a connection from the remote LOB server. This is the backwards-compatible default option.

    Default is Remote.
    Connection Name Enter ADT_ReceiveMLLP.
    Host name Specific to BizTalk Server 2013 R2 and older versions.

    Enter localhost.
    Local Host name New starting with BizTalk Server 2016.

    Enter the DNS name or IP address of the local BizTalk Server. You can also enter localhost.
    Port Specific to BizTalk Server 2013 R2 and older versions.

    Set to 22000.
    Local Port New starting with BizTalk Server 2016.

    Enter the TCP port number for the LocalHost connection. Applicable only when Connection Initiated by is Remote.

    Set to 22000.
    Remote Host New starting with BizTalk Server 2016.

    Enter the DNS name or IP address of the remote LOB server. Applicable when Connection Initiated by is set to Local.
    Remote Port New starting with BizTalk Server 2016.

    Enter the TCP port number for the remote host connection. Applicable when Connection Initiated by is set to Local.

    Set to 22000.

  9. Set the Receive Handler to BizTalkServerApplication.

  10. Set the Receive Pipeline to BTAHL72XPipelines.BTAHL72XReceivePipeline.

  11. Set the Send pipeline to PassThruTransmit.

  12. Select OK to save your changes.

  13. Enable the receive location you just created by right-clicking it, and then select Enable.

Next step

Step 5: Create the Receive Port for Accepting HIS Messages