Edit

Share via

SetDisplayConfig Summary and Scenarios

  • Article

This section applies only to Windows 7 and later, and Windows Server 2008 R2 and later versions of Windows operating system.

The following sections summarize how a caller uses the SetDisplayConfig CCD function and provide scenarios for using SetDisplayConfig.

SetDisplayConfig Summary

The caller can use SetDisplayConfig to apply a topology along with other display settings. That is, the caller can use SetDisplayConfig to set the topology, layout, orientation, aspect ratio, bit depth, and so on. The caller can use SetDisplayConfig to perform the following operations:

  • Set a particular topology of sources and targets.

  • Define the source and target mode for each path along with layout, orientation, and scaling factor.

  • Update the database while applying the display settings.

  • Test whether a particular topology that was constructed by using enumerated paths is possible.

  • Directly apply the last known setting from the database that maps to one of the four options from the hot key.

  • Enable forced projection on a target.

  • Invoke the new operating system best mode logic.

SetDisplayConfig Scenarios

SetDisplayConfig is called in the following scenarios:

  • The display control panel applet calls SetDisplayConfig to test all the possible options to populate the multimon drop-down box.

  • The display control panel applet calls SetDisplayConfig to apply the setting that a user selected from the drop-down menu.

  • The display control panel applet calls SetDisplayConfig to apply the settings that a user selected from the user interface. These settings include resolution, layout, orientation, scaling, primary, bit depth, and refresh rate.

  • After the user makes a selection, the display hot key calls SetDisplayConfig to apply the appropriate setting from the persistence database.

  • Tasks under the Control Panel user interface call SetDisplayConfig to apply the appropriate setting, which is based on the type of the task.

  • The display control panel applet calls SetDisplayConfig to start or stop forced projection on a particular target.