NDIS_WWAN_SET_SAR_CONFIG structure (ndiswwan.h)
The NDIS_WWAN_SET_SAR_CONFIG structure describes Specific Absorption Rate (SAR) information that a mobile broadband (MB) modem should use to set its SAR configuration.
Syntax
typedef struct _NDIS_WWAN_SET_SAR_CONFIG {
NDIS_OBJECT_HEADER Header;
WWAN_SET_SAR_CONFIG SetSarConfig;
} NDIS_WWAN_SET_SAR_CONFIG, *PNDIS_WWAN_SET_SAR_CONFIG;
Members
Header
The header with type, revision, and size information about the NDIS_WWAN_SET_SAR_CONFIG structure. The MB Service sets the header with the values that are shown in the following table when it sends the data structure to the miniport driver for set operations. Miniport drivers must set the header with the same values when they send the data structure to the MB service.
Header submember | Value |
---|---|
Type | NDIS_OBJECT_TYPE_DEFAULT |
Revision | NDIS_WWAN_SET_SAR_CONFIG_REVISION_1 |
Size | sizeof(NDIS_WWAN_SET_SAR_CONFIG) |
For more information about these members, see NDIS_OBJECT_HEADER.
SetSarConfig
A formatted WWAN_SET_SAR_CONFIG structure that describes the SAR information for the modem to set.
Remarks
This structure is used in an OID_WWAN_SAR_CONFIG Set request.
After completing the Set request, the modem should return an NDIS_STATUS_WWAN_SAR_CONFIG status notification as a response to inform the OS of the SAR configuration.
Requirements
Requirement | Value |
---|---|
Minimum supported client | Windows 10, version 1703 |
Header | ndiswwan.h |