GPIO_MASK_INTERRUPT_PARAMETERS structure (gpioclx.h)
The GPIO_MASK_INTERRUPT_PARAMETERS structure describes a set of general-purpose I/O (GPIO) interrupt pins to mask.
Syntax
typedef struct _GPIO_MASK_INTERRUPT_PARAMETERS {
BANK_ID BankId;
ULONG64 PinMask;
ULONG64 FailedMask;
} GPIO_MASK_INTERRUPT_PARAMETERS, *PGPIO_MASK_INTERRUPT_PARAMETERS;
Members
BankId
The identifier for the bank of GPIO pins that contains the interrupts to mask. If N is the number of banks in the GPIO controller, BankId is an integer in the range 0 to N–1. The GPIO framework extension (GpioClx) previously obtained the number of banks in the controller from the CLIENT_QueryControllerBasicInformation event callback function. For more information, see Remarks in CLIENT_CONTROLLER_BASIC_INFORMATION.
PinMask
A 64-bit mask to indicate which interrupt pins to mask in the specified bank. This mask affects only GPIO pins that are configured as interrupt request inputs. A bit in the mask that is set to 1 identifies a pin that is to be masked. All other bits in the mask are 0. If N is the number of pins in this bank, the pins are numbered 0 to N–1. Bit 0 (the least significant bit) in the mask represents pin 0, bit 1 represents pin 1, and so on.
FailedMask
A 64-bit mask that identifies the GPIO pins that could not be masked. If the GPIO controller driver fails to mask a bit that is indicated in the PinMask member, the driver sets the corresponding bit in the FailedMask member to mark this failure. If all pins specified in PinMask are successfully masked, the driver sets FailedMask to zero. For more information, see Remarks.
Remarks
The MaskParameters parameter of the CLIENT_MaskInterrupts event callback function is a pointer to a caller-allocated GPIO_MASK_INTERRUPT_PARAMETERS structure. This function affects only GPIO pins that are configured as interrupt inputs and that are part of the specified bank of GPIO pins.
GPIO controllers that have memory-mapped registers are expected to always succeed in setting the interrupt mask to the requested value. The FailedMask member is primarily intended for use by GPIO controllers that are not memory-mapped.
Requirements
| Requirement | Value |
|---|---|
| Minimum supported client | Supported starting with Windows 8. |
| Header | gpioclx.h |