IDebugControl2::GetExecutionStatus method (dbgeng.h)
The GetExecutionStatus method returns information about the execution status of the debugger engine.
Syntax
HRESULT GetExecutionStatus(
[out] PULONG Status
);
Parameters
[out] Status
Receives the execution status. This will be set to one of the values in the following table. Note that the description of these values differs slightly from the description in DEBUG_STATUS_XXX.
| Value | Description |
|---|---|
| DEBUG_STATUS_NO_DEBUGGEE | The engine is not attached to a target. |
| DEBUG_STATUS_STEP_OVER | The target is currently executing a single instruction. If that instruction is a subroutine call, the entire call will be executed. |
| DEBUG_STATUS_STEP_INTO | The target is currently executing a single instruction. |
| DEBUG_STATUS_STEP_BRANCH | The target is currently running until it encounters a branch instruction. |
| DEBUG_STATUS_GO | The target is currently running normally. It will continue normal execution until an event occurs. |
| DEBUG_STATUS_BREAK | The target is not running. |
Return value
This method may also return error values. See Return Values for more details.
| Return code | Description |
|---|---|
|
The method was successful. |
Remarks
For more information, see Target Information.
Requirements
| Requirement | Value |
|---|---|
| Target Platform | Desktop |
| Header | dbgeng.h (include Dbgeng.h) |