Configure network adapters in Lync Server 2013
Topic Last Modified: 2013-11-07
You must assign one or more IP addresses to the external network adapter and at least one IP address to the internal network adapter.
In the following procedures, the server running either Forefront Threat Management Gateway (TMG) 2010 or Internet Information Server Application Request Routing has two network adapters:
A public, or external, network adapter, for clients that attempt to connect to your website (that is, usually over the Internet).
A private, or internal, network interface, for internal servers running Lync Server that are hosting Web Services.
Important
Similar to the Edge Servers, you set the default gateway on the external network adapter only. The default gateway will be the IP address of the router or external facing firewall that directs traffic to the Internet. For traffic that is destined from the reverse proxy to the internal facing network adaptor, you must use persistent static routes (such as the route command in Windows Server) for all subnets containing servers referenced by the web publishing rules. Setting a persistent route does not cause the computer to become a router. If IP forwarding is not enabled, the computer is acting only to direct specific traffic destined for another network to the appropriate interface. This is essentially setting two gateways – one as the default pointing to the external networks, and one for traffic destined to the internal interface and on to a router or other network.
However, creating persistent routes for all subnets may not be necessary if your network’s routers are configured to summarize routes. Create a persistent route to the network where the router is defined and use the router as the default gateway. If you are not sure how your network is configured and need guidance on what persistent routes need to be created, consult with your company’s Network Engineers.
The reverse proxy must be able to resolve the DNS host (A) records for the internal Director or Front End Server and next hop pool FQDNs used in the web publishing rules. As with the Edge Servers, for security reasons, we recommend that you do not configure a reverse proxy to use a DNS server located in the internal network. This means you either need DNS servers in the perimeter, or you need HOSTS file entries on the reverse proxy that resolves each of these FQDNs to the internal IP address of the servers.
To configure the network adapter cards on the reverse proxy computer
On the Windows Server 2008, Windows Server 2008 R2, Windows Server 2012, or Windows Server 2012 R2 server running as the reverse proxy, open Change Adapter Settings by clicking Start, pointing to Control Panel, clicking Network and Sharing Center, and then clicking Change Adapter Settings.
Right-click the external network connection that you want to use for the external interface, and then click Properties.
On the Properties page, click the Networking tab, click Internet Protocol Version 4 (TCP/IPv4) in the This connection uses the following items list, and then click Properties.
On the Internet Protocol (TCP/IP) Properties page, configure the IP addresses as appropriate for the network subnet to which the network adapter is attached.
Note
If the reverse proxy is already being used by other applications that use HTTPS/TCP/443, such as for publishing Outlook Web Access, you either need to add another IP address so that you can publish the Lync Server 2013 Web Services on HTTPS/TCP/443 without interfering with the existing rules and web listeners, or you need to replace the existing certificate with one that adds the new external FQDN names to the subject alternative name.
Click OK, and then click OK.
In Network Connections, right-click the internal network connection that you want to use for the internal interface, and then click Properties.
Repeat steps 3 through 5 to configure the internal network connection.