Share via

Guide to enable SSL site collections using host headers to be browse able using ISA Server

  • Article

After setting up a SSL enabled site collection using SSL, with ISA running with a single rule, you are not able to browse to the SSL enabled site collection.  The cause for this is simple: each SSL enabled site collection must have it’s own rule set within ISA.  Here is a step by step guide on how to do so:

1. In ISA 2006, right click Firewall Policy, New, and finally SharePoint publishing rule; type a new name for the publishing rule.  Click Next.

clip_image002

2. Select Publish a single Web site or load balancer since we are dealing with a single site collection.  Click Next. clip_image002[12]

3. Select Use SSL. Click Next.

clip_image002[15]

4. Type the name of the published web site, which is the external URL as it would appear on the certificate.  Click the box next to Use a computer name or IP address to connect to the published server, and fill in the correct IP address for the server.  Click Next.

clip_image002[17]

5. From the drop down for Accept requests for, select This domain name.  In the Public name box, type in the domain name you wish to use.  Click Next. clip_image002[19]

6. We now must create a new listener.  Give the new listener a name.  Click Next. clip_image002[21]

7. Select Require SSL secured connections with clients.  Click Next. clip_image002[23]

8. Select External Network and then the IP Address.  This IP address will be dedicated to accept requests from SharePoint traffic externally.  Click on OK, and then click Next. clip_image002[25]

9. Click on Select certificate and select the correct certificate with the name you are using in the public name.  Click on Select. clip_image002[27]

10. Select the authentication type, and configure as needed.  Click Next. clip_image002[29]

11. If SSO is being used, click on Enable SSO for Web sites published with this Web listener, and configure the SSO domain being used for authentication.  Click Next. clip_image002[31]

clip_image002[33]

12. Click Finish.

 clip_image002[35]

13. Select the new Listener, and click on Next.

 clip_image002[37]

14. Select the NTLM authentication, and click on Next. clip_image002[39]

15. Select the first option if AAMs are already configured; if not select the second option. Click Next.

 clip_image002[41]

16. Select All Authenticated Users.  Click Next.

 clip_image002[43]

17. Click on Finish.

clip_image002[45]