Share via

BizTalk Error: Can Not Enable Receive Location

  • Article

Issue: When you refesh Application after enable the Receive Location, you find the Receive Location is still in Disable status.

Resolution: Check the configuration of Host / Host Instance, you may use a restrict user account.

Comments

  • Anonymous
    August 24, 2007
    I am also facing the same problem when I am trying to enable a remote receive location. Please help me if you have any idea.

  • Anonymous
    August 24, 2007
    I am also facing the same problem when I am trying to enable a receive location remotrely. Please help me if you have any idea.

  • Anonymous
    August 26, 2007
    Hi Kerrey,          I am facing this error while I am running a script to enable the recieve location the scrit runs without any error but I dont see the recieve locatons getting enabled. Disable script however runs fine and has the desired effect. You have written about some configurtion change can u elaborate it a little more. Regards Abir

  • Anonymous
    September 24, 2007
    Mostly,it's a credential issue Please right click host instance and check which user you are using. For remote issue, you must check SSO, because all configuration for Adapters are stored in SSO.

  • Anonymous
    March 18, 2008
    I have the same problem. I am using a group for host and a user which is in this group for the host instance. Both group and user is the administrator of the machine. Is anyone has the same problem?

  • Anonymous
    April 22, 2008
    I'm trying to enable and disable a host instance and meeting the same problem. The script runs fine and when I check the status of the host instance (using 'IsDisabled') it says it was disabled before and then enabled. However, when I check the status of the host instance in BizTalk Administration console it is still disabled. I can still start/stop the host instance using a script successfully - I just cannot enable or disable it.

  • Anonymous
    April 23, 2008
    To Roy: Check the property of host instance. Kerrey

  • Anonymous
    April 24, 2008
    The comment has been removed

  • Anonymous
    June 16, 2008
    The comment has been removed

  • Anonymous
    January 24, 2011
    Hi all, i am working on Biztalk software factory and want to disable the send ports and receive locations while i am deploying the solution. i tried alot but nothing is working, can anyone tell me how to do this.

  • Anonymous
    May 02, 2011
    In my case none of these tips worked while troubleshooting my teammates test projec at my new job. It turns out that looking at the host instances revealed that the servers are clustered sitting on the same MessgeBox DB. Error was reported on Server A. On the server B with which issues weren't reported as it was not physically used for testing the local physical Receive location the binding pointed to did not exist. Once I created the folder on server B and logged in to server A, I was able to enable the Receive location.