Start-InformationBarrierPoliciesApplication
This cmdlet is available only in Security & Compliance PowerShell. For more information, see Security & Compliance PowerShell.
Use the Start-InformationBarrierPoliciesApplication cmdlet to apply active information barrier policies in the Microsoft Purview compliance portal.
For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.
Syntax
Start-InformationBarrierPoliciesApplication
[[-Identity] <PolicyIdParameter>]
[-CleanupGroupSegmentLink]
[-Confirm]
[-WhatIf]
[<CommonParameters>] Description
To use this cmdlet in Security & Compliance PowerShell, you need to be assigned permissions. For more information, see Permissions in the Microsoft Purview compliance portal.
Examples
Example 1
Start-InformationBarrierPoliciesApplicationThis applies all active information barrier policies.
Parameters
-CleanupGroupSegmentLink
The CleanupGroupSegmentLink switch specifies whether to remove group segment links. You don't need to specify a value with this switch.
| Type: | SwitchParameter |
| Position: | Named |
| Default value: | None |
| Required: | False |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
| Applies to: | Security & Compliance |
-Confirm
The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.
- Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax:
-Confirm:$false. - Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.
| Type: | SwitchParameter |
| Aliases: | cf |
| Position: | Named |
| Default value: | None |
| Required: | False |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
| Applies to: | Security & Compliance |
-Identity
This parameter is reserved for internal Microsoft use.
| Type: | PolicyIdParameter |
| Position: | 0 |
| Default value: | None |
| Required: | False |
| Accept pipeline input: | True |
| Accept wildcard characters: | False |
| Applies to: | Security & Compliance |
-WhatIf
The WhatIf switch doesn't work in Security & Compliance PowerShell.
| Type: | SwitchParameter |
| Aliases: | wi |
| Position: | Named |
| Default value: | None |
| Required: | False |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
| Applies to: | Security & Compliance |