Επεξεργασία

Κοινή χρήση μέσω

Remove-DlpCompliancePolicy

  • Reference
Module:
ExchangePowerShell
Applies to:
Security & Compliance

This cmdlet is available only in Security & Compliance PowerShell. For more information, see Security & Compliance PowerShell.

Use the Remove-DlpCompliancePolicy cmdlet to remove data loss prevention (DLP) policies from the Microsoft Purview compliance portal.

For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.

Syntax

Remove-DlpCompliancePolicy
      [-Identity] <PolicyIdParameter>
      [-Confirm]
      [-WhatIf]
      [<CommonParameters>]

Description

To use this cmdlet in Security & Compliance PowerShell, you need to be assigned permissions. For more information, see Permissions in the Microsoft Purview compliance portal.

Examples

Example 1

Remove-DlpCompliancePolicy -Identity 7e640345-1a7f-4f4e-9c17-681c070ed5e2

This example removes a DLP policy specified by its GUID.

Example 2

Remove-DlpCompliancePolicy -Identity "PII Main Policy"

This example removes a DLP policy specified by its name.

Parameters

-Confirm

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.
  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.
Type:SwitchParameter
Aliases:cf
Position:Named
Default value:None
Required:False
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance

-Identity

The Identity parameter specifies the DLP policy that you want to remove. You can use any value that uniquely identifies the policy. For example:

  • Name
  • Distinguished name (DN)
  • GUID
  • Id
Type:PolicyIdParameter
Position:1
Default value:None
Required:True
Accept pipeline input:True
Accept wildcard characters:False
Applies to:Security & Compliance

-WhatIf

The WhatIf switch doesn't work in Security & Compliance PowerShell.

Type:SwitchParameter
Aliases:wi
Position:Named
Default value:None
Required:False
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance