Επεξεργασία

Κοινή χρήση μέσω


Remove-AutoSensitivityLabelRule

This cmdlet is available only in Security & Compliance PowerShell. For more information, see Security & Compliance PowerShell.

Use the Remove-AutoSensitivityLabelPolicy cmdlet to remove auto-labeling policy rules from your organization.

For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.

Syntax

Remove-AutoSensitivityLabelRule
      [-Identity] <PolicyIdParameter>
      [-Confirm]
      [-WhatIf]
      [<CommonParameters>]

Description

To use this cmdlet in Security & Compliance PowerShell, you need to be assigned permissions. For more information, see Permissions in the Microsoft Purview compliance portal.

Examples

Example 1

Remove-AutoSensitivityLabelRule -Identity "Social Security Rule"

This example removes the rule named Social Security Rule.

Parameters

-Confirm

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.
  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.
Type:SwitchParameter
Aliases:cf
Position:Named
Default value:None
Required:False
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance

-Identity

The Identity parameter specifies the auto-labeling policy rule that you want to remove. You can use any value that uniquely identifies the rule. For example:

  • Name
  • Distinguished name (DN)
  • GUID
Type:PolicyIdParameter
Position:0
Default value:None
Required:True
Accept pipeline input:True
Accept wildcard characters:False
Applies to:Security & Compliance

-WhatIf

The WhatIf switch doesn't work in Security & Compliance PowerShell.

Type:SwitchParameter
Aliases:wi
Position:Named
Default value:None
Required:False
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance