Freigeben über

Forwarding on the 6to4 network interface cannot be enabled

  • Artikel

An error you might run into when activating a DirectAccess configuration is the dreadful “Forwarding on the 6to4 network interface cannot be enabled”:

clip_image002

This often happens after you rebuild a server, and try to restore a configuration from backup, and is typically caused because of a duplicate 6to4 interface.

The first step of resolving this is to enable the interface manually, which is done this way:

1. Find the name of your 6to4 adapter by running the command netsh int ipv6 show int. This would often be “6to4 adapter”

clip_image004

2. Enable forwarding by running the command netsh int ipv6 set int <NAME> forwarding=enabled where <NAME> is what you found in step 1

clip_image006

Now, try activating DA again from the UAG console. You would probably be disappointed to see it fail again. If so, the reason is probably because the computer has duplicate 6to4 adapters, confusing the server. If so, you can easily fix this by removing the interfaces from the Device Manager:

1. Open Device Manager

2. Click View and select “View Hidden Devices”

clip_image008

3. Notice the two 6to4 adapters? There’s your problem. Remove both of them by right-clicking and selecting “uninstall”.

4. Close the device manager, and reboot the UAG server.

5. After a reboot, the 6to4 adapter will be re-added, but only once, so you should be good to go.

6. Activate the UAG configuration again, and this time, it should be fine!

Blog post written by Ben Ari

Comments

  • Anonymous
    February 11, 2011
    The comment has been removed